20 Most Recent Whirlpool GU2400XTP Built-in Dishwasher - Page 5 Questions & Answers

Hi,

I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms online and installed them in minutes...now the thing works like new... However I have also found that if the heating element goes bad then that also can mess things up bad... So I would buy new spray arms, and also check out the heating element to make sure it is working... Here is a tip that will help you with the online buying... Dishwasher Spray Arms not SpinningHow to Buy Appliance Parts OnlineA bad heating element causes many problems in dishwashers...Dishwasher Problems The Heating Element not WorkingDishwasher Maintenanceheatman101 wert

sounds as if your door latch/handle is broken internally.your dishwasher is installed with 2 screws to theunderside of your countertop. its tricky but youll have to remove them (adjusting to leveling legs down will give you more room to get some kinda a phillips head bit in ther to remove the screws), once out slide the d/w foward and remove the strike plate door will open at least get your dishes out

how many flashes

check the power coming out of both

Hello,

press normal heated dryer normal heated dry normal the dishwasher should reset and start. You will need to check the heater this happens because the heater normally fails. Let me know,

http://www.appliancerepairlesson.com/

test the pwr at the plug where it plugs in...if you have power..and lights on the front..then mabe a door sensor? if no lights..its replacememnt time..

Probably not. BUT the tenant may be opening the door before the rinse/dry cycles are complete. You can change the water temp selection by changing the wash setting. settings like "high temp" and "pots and pans" on most machines will wash in hotter water. try closing the door and press and hold the start button. that might pump out remaining water. also Make sure drain hose (under the sink) has not been moved.

Have you washed the hob recently? If so there is a good chance moisture has found its way into the ignition switch. If this is the case it should cure itself once it has dried out.