20 Most Recent Whirlpool AWM9000 Front Load Washer - Page 8 Questions & Answers

The error code F7 indicates there is a problem with the motor. It fails to get to the required speed for the wash cycle. Make sure the drum isn't too full. Also make sure all transit bolts are removed.

use a meter to diagnosis what has failed --breaker - circuit - motor - etc

Could be a defective cycle timer or failure of some element controlled by the timer such as the pump.

The drum may need to be replaced for your washing machine and the parts that allow the drum to rotate might also need to be replaced as well.

see if power to control board

It may be the capacitor

Disconnect tube to switch. Let basin fill to full. Reconnect tube(clear plastic hose)

Something could be stuck inside of your washing machines drain or the hose could be needing to replaced or the hose could be kinked or twisted or have holes in it. Or the wires are either broken or loose in the water valve or the washing machines wiring harness and have to be replaced.

Put some shims under the leg that has a gap between the leg and floor.

No reset button. Try unplugging the unit and wait 30 minutes. Then plug it in and try it.

1. Search for the end of cycle signal button then on your dryer This button is located right on the right side of the Duet model dryers.
2. Push and then hold the button down for about 3 seconds.
3. The Control Lock LED should shut off then letting you know that your dryer is not locked anymore. Or it could be the child lock feature was turned on and needs to be turned off.

It is probably a power supply issue. I would replace the main smoothing and secondary smoothing capacitors on the main board. The voltages go lower than they should be and it confuses the board.

read the manual yet, why not? most things like this need a new filter and need fully cleaned. or condensate pan is too full of water. all this is in the manual if you read it. and keep it on hand as manual like to go byebye old on the www https://www.manualslib.com/manual/1834294/Whirlpool-Wdh70eapw.html see page 10 drain hose ALL WRONG got the optional PUMP< we can't see it./ it says clear as day E1 E2 is call for service why not do as it tells.

The pump might need to either be replaced in your washing machine or the pump could be clogged. To check the pump you will have to first disconnect the drain line and then remove the back panel on your washing machine and use a flashlight.

You need a service call. This is a fault with the Start Capacitor Motor Control Board, or the main control board. These machines have a computer controlled variable speed motor. Everything should be silent when it is switched off, so this leads me to believe it is a board issue.

For some of the Whirlpool washing machines to turn off the the signals press and hold the signal cycle for about a few seconds to turn it off and for other models touch and then hold the steam clean option for about 3 seconds to turn off the tone.

https://www.youtube.com/watch?v=zrgf0WVIukk This will answer your question.

Change the Thermistor which is the temperature sensor. Or you could turn the cold water off when you do a Sanitary wash.

Your washing machine might not be evenly balanced so it is shaking very roughly when the spin cycle is running.Redistributing the load will most of the time fix this problem here if it is caused by having too many clothes on one side of your washing machine.

a magnet won't work unless you necklace was made of steel and that is very unlikely. Magnets only work on Ferrous metals, so gold, silver, brass, copper or any plated items won't stick. The necklace in there somewhere. Under the base is the pump and that is connected to a flexible pipe from the base of the drum. Pull the machine out and look at the rear. The pump is easily accessible, plus they have a filter. Videos in the link. The better search query would be 'make model remove pump'. https://www.google.com/search?q=top+loader+whirlpool+remove+pump+filter ..