Lucent PARTNER18 Corded Phone - Answered Questions & Fixed issues

No such password 3exists.

I believe you have to Program one of the keys to do that. code is *783

This should solve your problem https://www.youtube.com/watch?v=XWlFtwTCtqU

Use Liquid Paper or any other correction fluid.

It prob in DND mode - if this is right phone http://www.beatriceco.com/bti/porticus/bell/pdf/bsp/518457701_avaya_how_to_use_your_partner_phone.pdf

Have you tried this ...In ASA, enter the command ch sta xxxx.Select tab 2In the second column of features , you will see "Auto Answer". This should be set to "none".Good Luck!

The caller ID information is sent between the first and second rings, so there's no way the receiving phone can display this data on the first ring. You have to wait for the second ring (or just before it).

you must have to read your instr. manual for to exchange the ID.go to section operation , and fix it.God bless you

You cannot transfer an INTERCOM call.

switch it off. if it uses a battery, remove the battery and then switch it on again

What happens when you dial 777 on the intercom? If you get Partner mail, then it's a start. Now you just need to find out which one and the admin password. Normally it's 99 for admin access and the password is defaulted to 4321. I'd be searching the internet for a manual.Carl

A tall order, but here's a start http://www.wedophones.com/Manuals/AT&T/PARTNER%20ACS%20R6-0%20Installation%20Programming%20and%20Use.pdfCarl

How do I change the names that are asigned to certain extenions??

Avaya Partner System Time Program #103 Considerations: Enter the time in 24 hour notation. In this scheme, the hours of the day are 0000 (12 midnight) to 2459 (11:59). Since each time must have four digits, use leading zeros when necessary. The time appears on system phones as A.M. or P.M., not 24 hour notation.
Programming: To change system time: Press Feature, 00, System Program, System Program, #,103 at extension 10 or 11. Enter a new time in 24 hour notation. For example, to set time to 2:15 P.M., press 1415. This time will appear on the phone as 2:15 P. Select next procedure or exit programming mode by pressing Feature, 00 or lifting and hanging up the handset.

that is based on the network you use. The will be a number provided by your network provider you can call to change it. I will advice you call the customer care of the network you use for that number. Or which network?

If the Comcast people changed the equipment in the phone room they probably ran direct lines to each phone or put filters in the lines. The reason you're not seeing the lines light up is the phones are not wired correctly now. The cable box that all of your lines are coming from must have a 1 to multiple line adaptor for each line. The adaptor feeds all of the phones. Communication for the intercom and the line in use lights goes down the phone lines so ther has to be a direct connection between all of the phones. If there are filters in the lines they must be put between the cable box and the line splitter. You can get the line splitters at Radio Shack (Model 279-435 for 1 to 3 adaptor).

Sounds like the line 3 button on that set is programmed as something else. When you press feature 00 and the line 3 button what does the programming say on the screen?

you can contact the mobile service provider........

Call in a pro. it sounds like you lost all your programming with that power outage.
Depending on your processor type, you may have to re-program teh entire system, or just restore a backup....

you can contact the mobile service provider........