20 Most Recent DeLonghi EAM3400 Espresso Machine - Page 9 Questions & Answers

Not clear if loss of steam to milk dispenser or milk dispenser itself clogged.

Try descaling again. Try running the vinegar through tbe machine about 1/2. Then stop tbe machine and allow additional time for the vinegar to work.

Also run a clean cycle using vinegar.

Also try disassembling the milk dispenser and clean manually.

Could it perhaps be a limescale indication? If so add descaller and hold start button for 5 seconds.

to me the pipe is blocked there is a tool to use to clean this pipe out, hard deposits in the water can block the steam pipe and the tool is a thin bendy wire that you put up the pipe to clean the pipe line out. i would think they sell this pipe in most out lets for coffee makers. check for coffee steam pipe cleaner.

you have to do Descaling

iuf yuou have the ESAM 4500 YOU CAN FROM THE MILK CONTAINER , if its older model it dose not .

you have to tern the machine off then to assemble the infuser

Most likely the heating element would have to be changed the water will not come out till it reaches its temperture

I'm not sure about your specific machine, but in general: Make sure you have the correct size and shape filter, measure carefully so as not to overfill, check that the grind is not too fine and plugging the filter. This can cause the filter to overflow and grounds float into the pot.

http://www.fixya.com/support/t11896966-delonghi_eco310_replace_steam_knob https://www.quenchessentials.com/delonghi-eco310-icona-manual-espresso-machine.html

https://www.youtube.com/watch?v=uOF9FL3HQeU

http://www.fixya.com/support/t26188048-delonghi_machine_says_empty_grounds

http://kavegepbolt.hu/shop_ordered/9160/pic/Saeco/DELONGHIESAM5500.pdf

The 'o' rings that come on the steam wand at purchase are rubbish. They come off easily without you even noticing when you remove the parts for cleaning after each frothing. The replacement o rings from DeLonghi do the same thing. I eventually went to my local coffee machine repair shop and got an o ring from them. It has never come off in the year and a half since. . . . . and I have no problems with my Magnification S. Now I LOVE my coffee machine!!!!!!

https://m.youtube.com/watch?v=mM5PRiOD8jI

If spout pops out it may be clogged - clean spout with compressed air and small wire run all the way thru the spout. Additional help at this link "https://www.6ya.com/philip_b05beb373d913f26"

This is a step by step of how to make a 8oz cup of cofee: https://www.youtube.com/watch?v=FOCLtmsLSIY

Dod you close the valve for the steam to escape and is there enough milk in the frother compartment?