20 Most Recent Whirlpool GLT3034 Gas Cooktop Questions & Answers

Hi,
Here is a tip that I wrote to help people troubleshoot problems with their cooktops not igniting.

Cooktop Range Stove spark ignition does not work
http://www.fixya.com/support/r5649407-cooktop_range_stove_spark_ignition_not

heatman101

Hi,
Here is a tip that I wrote that will help figure out why the burner spark keeps on clicking...

Gas Range Repair Burners Keep on Clicking
http://www.fixya.com/support/r4033033-gas_range_repair_burners_keep_clicking

heatman101

Here is a disassembly video. A loose knob problem can be tackled by pulling off the knob, encircling the cracked plastic with a zip tie (after putting Loctite glue in the cracks), pulling the zip tight. Don't lose the sleeve when you pull off the knob. But if this is not working for your setup, here is the disassembly, not your model but maybe useful: https://www.google.com/search?q=whirlpool+gas+top+disassembly

GET IT REPLACED .BY A PRO.

https://cooktophunter.com/common-troubleshooting-solutions-for-induction-cooktops/

Cleaning or replacing the grease filters in downdraft vent hood

Can you get to the switch terminals and try jumping them out with a piece of insulated wire? That would tell you if the switch is defective (my suspicion). Please be careful not to touch any live terminals - only the wire insulation you use for the jumper.

unplug it and replace the main board or get a new stove

What is the model number?

You didn't mention if it only pops when you first turn them on or that the popping is continuous. If it when you first turn them on, then I would suspect late ignition. Too much gas build-up before ignition takes place. The spark gap may need to be adjusted or the spark module replaced. If it happens continuously there may be a short in one of the switches or wiring harness.

and the problem is? please post afresh with full details