20 Most Recent Rockwood X-Plore AMP-4040 Car Audio Amplifier Questions & Answers

with a maximum of 700 watts, it would need a 60 amp fuse

Call A Rockwood repairing dealer or go in their website to get the factory's phone number.

simply use the two outside speaker connectors in order to bridge them

Rockwood was a very low level brand. Alot of their amps were not brigeable. If bridge able the bridge terminals should be marked (usually the positive of 1 channel and the negative of the other channel). Under no circumstances bridge to less than a 4 ohm load.

If its u run the speak wires to each on its called. But if u want run the speakerd in 4 ohm just run in seriou way

You must connect the amp to a power supply capable of 12VDC at over 30 amps and either have built-in current limiting capability or install a fuse in-line with the power wire.