20 Most Recent Yamaha RX-V473 5.1 Channel Network AV Receiver - Page 6 Questions & Answers

review the user manual page 101 to use zone 2.

The audio outputs on the rear of the TV (if present) should be connected to the audio inputs on the rear of the receiver. From your description, it seems the present connection is incorrect.

Hi. I have rxv773 and it had the same problem. If u turn it on and after reley clicking 2 times fast and 1 time after about 8 seconds, look at the display if you see speaker ikons. If u don't see them and there is no sound. You wait those 10 minutes when sound comes back and look if the icons apear at the same time you got sound. If that is the case, you have bad DSP chip inside on the hdmi board. You could open the yamaha cover and see it right away on the top board at the right side. The chip is D80YK113CPTP4. That is the bad one. If you apply a heat for about 20 to 30 seconds with the heat gun at medium settings, you could fix the problem for a day or two or maybe a month. You need to replace the chip with newer one D80YK113DPTP4 . That dptp4 is updatet chip from cptp4. You can find those on aliexpress.

Unless it has fuses, you could have blown any component on the board. If that is a power supply on the upper right, look in there for a glass fuse. If you can't find a fuse, you need a Yamaha Audio Service Centre as they have the test equipment and access to the ICs and other components. Repairing audio equipment is no longer possible with a tester and a soldering iron, you need oscilloscopes, IC testers and other test equipment, plus a full schematic and the knowledge to read it..

never had a cap that would fix itself been doing fixes with electronics for 60 yrs

Here is the User Manual of R-N803 Check Restore Setting Page 53 Link: https://usa.yamaha.com/files/download/other_assets/8/976638/web_ZX95350_R-N803_R-N803D_om_URL_EnFrEs_A0.pdf If this work for you, Please Subscribe Our YouTube Channel: CCTV Networking Technical Support and website: https://www.doitek.net

On Yamaha's official website then for the remote that you need.

Power supply failure

Check there is mains power still at the amplifier/receiver. Display?

I have seen several things that can cause this. One is a capacitor that holds the memory in the cpu. Another is a voltage regulator and then there are failures in the final amplifier transistors

Unplug all your speakers and components. Then turn on, if it still locks up you have one of maybe 5 safety features hooked up that are built in to stop your amp from blowing. You will need to replace board or have some cool tech dude desolder and isolate . Look for wiring diagram for safety shut down system. Sorry but if it doesn't do it after you disconnect every thing then check each speaker with ohm meter to read factory specs.

Yes but only limited functions! like Volume and on and off.

1. Open internal fuse 2. Power supply failure

Either you accidentally turned off the centre output or something inside has died. I suggest you read the user manual for a start...

I bought a damaged rx v1 to repair it and I measured everything and according to the voltages it is ok but and repair it

It is going in to protect mode. Needs to be serviced.

Service manual for sale: https://www.service-manual.net/?download=67190-yamaha-rx-a1060-rx-v1081-service-manual

Just connect the VX7 to the 5730 using an RCA Y cable. It should help

https://www.manualslib.com/manual/853438/Yamaha-Crx-E150.html

Should have very small hole, insert straightened paper clip to eject. Alternately accelerate it at 32bft per sec sqd