Bosch Nexxt 500 WFMC3301 Front Load Washer - Answered Questions & Fixed issues
Fabric softener dispenser fills up with clear water after
Purchase some fabric softener and place it in its normal location at the beginning of the cycle. At the end of the cycle check to see if fabric softener has been dispensed and whether there is water in the cup.
If the fabric softener is gone, but there is water in the fabric softener cup, then your problem may be with the water valve assembly. The water valve assembly (as one complete unit) has a separate solenoid for hot and cold water temperatures, bleach and fabric softener. The fabric softener solenoid on the water valve assembly could be defective (allowing water to fill the fabric softener cup).
Contact an appliance service company.
All wash cycles keep prematurely stopping. I am not getting any error codes.
The programmer itself might be at fault
No cycles complete .... but does the machine stop at the same part of each cycle, i.e. the rinse or the spin. If it does you can
ascribe the fault to a particular component.
If it is stopping at different points it would probably be the programmer.
A technician should be able to definitively diagnose the fault
Error code E:01
Hi and welcome to Fixya,
The E01 error for your bosch indicates a door lock problem has been detected at the control board. Insure the door is closed tight, turn your breaker off or unplug the washer for a couple of minutes and retry. Let me know what happens, ultimately it may be a faulty lock assembly, a loose wire harness etc. but we'll cross that bridge when we get there...if necessary.
I'll watch for you to respond with the result's.
Good luck.
Macmarkus :)
How do I use the bosch washer drum sanitizer cycle?
I don't have my Bosch washer any longer, but if I recall correctly there is a specific "cycle" for the sanitizer cycle, just drop in the tablet ( a specific product for high efficiency washers) and run the cycle.
Not finding what you are looking for?