20 Most Recent Whirlpool 25.6 cu. ft. Side-by-Side Refrigerator with In-Door-Ice Dispensing System - Page 7 Questions & Answers

Hi Bob, my name is Roger and i'd be glad to help you, but first could you provide the model and serial number of the unit? I’m happy to help further over the phone at https://www.6ya.com/expert/roger_e8672cfe67bf61a1

generally there is a Philips screw at the edge of the plastic cover,or sometimes you can squeeze or press in the sides of the cover.Check the make & model and go in line to the company,They usually will have a manual where you can find out the answer.Best of luck.

There is a good chance that the clear shield has come out of its mount and is jamming the mechanism. Check to see if this is thae case. It is a bit tricky to get it back in but you should see a tab on the back side of the shield and it clips into a slot on the actuator arm.

freezer maybe turnedup to high ck manufacturing recommendations

That sadly is not enough information to answer this question. However, if you open the doors does the noise go away? If you chose the door after, does it come back? If it does NOT come back after you open and close the door. Then we have ruled out the evaporator fan. If it does, the evaporator fan is bad and will require being replaced. That is the first place to start however, there are also other options in the wide world of things that break. So, if you can please try that smiple test first.

Sadly, you will need to replace the entire 'flapper' assembly for this machine to fix this problem. This is the part in question. 8201649 for Whirlpool side by side. However, I would suggest if you can find the entire control panel assembly (which would be MUCH easier and have less chance to break things) to do that instead. However, clearing the shoot wont do a thing for this issue at all. Hope this helps ya ^_^

If you have a inline filter on its about stop up need to replace it. If you don't have one then the filter on water valve is stopping up. You need to turn water off going to ref. and take water line off and clean out filter inside water valve then put it back and it should work fine after.

Board is probably shot again Should be able to return board for free for a new one Then it sounds like the board is shorting out probably due to poor ground wire

haven't figured out the solution for the one I am working on yet.

Do all the test you can on your fridge,but do this one in particular that I use.Place a small window fan behind the fridge sitting on the floor and blowing lightly across the lower coils under the fridge.This will fake out the system making it think everything is fine and reset the original fan that does this over the lower coils.If the fan starts running again after a day,your done.If it doesn't,replace the lower fan.Or just leave the window fan blowing across the coils.

Have you changed the water filter lately? They need to be changed every 6 mos. They clog up and restrict water flow to your dispenser at the door.