Top 20 Power Acoustik PTID-8960 Car Video Player - Page 3 Questions & Answers

0helpful
1answer

How do i stop a power acoustik pd-450 from randomly shutting off? Ive checked connections and wiring all is good, the power supply is good as well

how random is it? Make sure the radio is grounded properly. Look in the pin outs in the harness and make sure there is a ground there. Also, you may have 1, 2, 3, or 4 bad speakers. A short in any one speaker will send the radio in protect mode. Also, If your radio is seeing less than something around a 3ohm load (technically 4) it will protect itself as well. I’m happy to help further over the phone at https://www.6ya.com/expert/chris_7f7f91eb941fb23f
12/26/2014 10:33:38 PM • Power Acoustik... • 1,509 views • 0 helpful votes
0helpful
2answers

I have a Power Acoustik Dem0n II 6000w amp. Every few seconds or so, it cuts off. In addition to the constant power outages, the amp is almost always hot. Can someone tell me what the problem might be

be sure the amp is located in a well ventilated area as heat build up can cause a safety override to cut power once temp. reaches a certain point. amps do generate heat though so if you dont think its cutting out due to excessive heat building up, i'd definitely get a power capacitor to help keep a steady supply of electrical energy available for instances where the bass hits really hard or for prolonged periods of time. if you have a power cap already make sure it doesnt need to be upgraded to function properly. hope this helps!
2/14/2015 4:54:24 PM • Power Acoustik... • 248 views • 0 helpful votes
0helpful
1answer

My power acoustik ptid-6250 will not cut on anymore. I was listening to it and it started going in out. Then all of sudden it just went out and won't come back on. How do I fix it ?

Going in and out sounds like the antenna cable got loose, but the not turning on sounds like the fuse blew. Worth checking those 2 things out first and foremost. Do you still have your owner's manual? If not: http://www.poweracoustik.com/pa2012/manuals/PTID-6250.pdf
1/27/2015 7:38:53 PM • Power Acoustik... • 158 views • 0 helpful votes
0helpful
1answer

My power acoustic ptid 8920 only has about 30 hrs playing time that I have used it for so therefore its practically is new the screen shows only half which is the right side of screen and its distort

You should still have warranty and If so I would send it in for repair. The ribbon cable could be bad if it is a flip out style.Good Luck !
1/19/2015 10:07:50 PM • Power Acoustik... • 111 views • 0 helpful votes
0helpful
1answer

How can i get a harnest and plug for power acoustik PTID-4003 car video player

Call Power Acoustik and tell them you had it for a few years and used it in a few cars so the harness has been chopped so short you need to get a new one. I'm sure if it was originally yours, they will want a receipt for the stereo brand new and they may sell it to you if it is available. If not, I sell new Soundstream Stereos at a very low discounted rate, as well, Power Acoustik. Check out the link below, we are the lowest price online for any of their products because we are closing all of the products out since they have driven the product line down to portray them as low as Dual and Craig., as a matter of fact, the products are all great, but, they do not protect their dealers and allow distributors to sell them online on Ebay, cheaper than the delaer's cost with free shipping, which has driven us away from them because we can't make a profit. Anyway, they should be able to sell you one, if not, give me a call or check our site, we sell their distributed products as well and may have a harness available on the website. Marc http://advancedelectronic.net/
11/25/2014 2:12:35 AM • Power Acoustik... • 108 views • 0 helpful votes
0helpful
1answer

Como poner otra caratula a mi power acoustik ptid-700nr?

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. Do a search by type in the brand name of your device at its search box and press "Enter". http://electronicshelponline.blogspot.com/ Translation option is there by the right side pull up gadget bar.
7/23/2014 5:38:04 AM • Power Acoustik... • 220 views • 0 helpful votes
0helpful
1answer

Video output harness

[email protected] 800-832-4647 x297 Mon-Fri 8:00AM - 4:30PM Pacific Time
2/27/2014 8:50:13 PM • Power Acoustik... • 115 views • 0 helpful votes
0helpful
1answer

Red light mean amp

it is in protection mode, Double check your wires and make sure that every wire is hooked up right. if not then you need a new amp.
11/13/2013 1:32:15 AM • Power Acoustik... • 75 views • 0 helpful votes
0helpful
1answer

Speakers "pop" on and off but no sound while its

you could have a shorted speaker I would disconnect all speakers and test them 1 at a time to see if you can get the amp to make some sound before I did anything.
8/7/2013 7:30:27 PM • Power Acoustik... • 113 views • 0 helpful votes
0helpful
1answer

Subwoofer making static noise

first of all,do u have the strip wire in the red which is the hot side of the sub,next if that doesn't fix it u need to change ur spark plugs they will interfere when the engine is running,so call ur local auto parts dealer and ask for spark plugs that don't interfere with the radio.Hope this helps
4/3/2013 6:22:47 PM • Power Acoustik... • 198 views • 0 helpful votes
0helpful
1answer

Amp shuts off then on

It's getting so hot that it's going into thermal protection. Turn down the gains of lighten the speaker load. The more speakers that hook up to it the more power it will put out causing the amp to overheat. Eventually it will burn up some of the output Mosfett Power Transistors.
4/1/2013 4:19:58 AM • Power Acoustik... • 100 views • 0 helpful votes
1helpful
1answer

My power acustik 1200 watt amp is on protection mode how do i fix it

Check that no speaker wires or some other wire come off, If they all look okay, There is a internal problem with the amp, It will have to be taken in for repair,
10/30/2012 2:51:46 PM • Power Acoustik... • 393 views • 1 helpful votes
0helpful
1answer

Screen flips and the turns off

Assassin's Creed IIICapturing a sense a serious amounts of place has always been central towards appeal of each Assassin's Creed. If the dusty streets of Masayaf, the c**** veined archipelago of Venice or even the sun baked Constantinople, everyone of Ubisoft's chosen settings has been designed with such a level of authenticity and historical accuracy (albeit twisted because of their narrative purposes), which it's quite normal you just read stories of tourists having the capacity to make their way around Rome simply from having memorised the map in Brotherhood.It's hardly surprising then that with Assassin's Creed III Ubisoft have absolutely nailed a recreation of 18th century revolutionary America. It's a sprawling land of open forest, bustling colonial cities and epic naval warfare, loaded with wildlife, frontiersmen and Redcoats. Many techniques from the lengthy reload animation of the period musket, towards the recognisable compacting crunch of jumping though waist high snow may be meticulously designed: not since Red Dead Redemption's Wild West comes with an American frontier been so fully realised and engrossing.The burgeoning wooden structures of Boston and New York play much like the brick tiled buildings of Europe, albeit after a little less verticality and wider streets. However it's from the forested areas that people understand why Ubisoft think worthy of another numbered entry in the series, rather than a subtitled sequel. The pine-valleyed frontier is usually a technical and visual marvel, and whilst there's a little too much conveniently angular geometry operating in the series' trademark free running gameplay, it's varied enough to weave a convincing illusion. The width, depth and breadth on the " new world " can be a grand ambitious statement of intent from Ubisoft - this really is their American epic.
11/13/2012 1:40:29 AM • Power Acoustik... • 210 views • 0 helpful votes
2helpful
1answer

D1-3000d

check the signal cable, there could be interference that causes a high peak that keeps the protection light on because of constant high output
6/11/2012 3:33:25 AM • Power Acoustik... • 226 views • 2 helpful votes
0helpful
1answer

The outputs of my 2300 power acoustic stopd workin

discus clearly.what's your problem ?
5/30/2012 2:38:11 AM • Power Acoustik... • 68 views • 0 helpful votes
1helpful
1answer

Power acoustic lt620-2

It's a straight forward swap, just make sure you line up the cathode leg (the one nearest the stripe) the right way before you solder.If the are any resistors around the capacitor it's worth changing them too, things don't normally blow on their own.The caps and resistors are easy enough to get hold of from maplin or RS.Good luck
4/22/2012 2:29:40 PM • Power Acoustik... • 150 views • 1 helpful votes
0helpful
1answer

My screen comes on until it goes to flip up then

you need to get your ribbon cable replaced. It's a cable that goes from the face to the main unit. they go out a lot. My suggestion is the next radio you buy, make sure it has no moving parts. Try to find the part at pacparts.com. I’m happy to help further over the phone at https://www.6ya.com/expert/chris_7f7f91eb941fb23f
5/21/2012 3:58:51 AM • Power Acoustik... • 71 views • 0 helpful votes
0helpful
1answer

It turns on then blows all the fuses

HelloCheck for any short circuit with wiring of the amp. If there is no such fault, surely your amp need service. It has some internal shorted components. This work is really a skilled one, and can only be done by any experienced service personal only. OK.
1/17/2012 5:10:15 AM • Power Acoustik... • 149 views • 0 helpful votes
0helpful
1answer

My friend said he fried

Unless he connected the black to positive and the red and yellow to negative, it should not have fried his dvd player.
7/13/2011 3:10:39 AM • Power Acoustik... • 381 views • 0 helpful votes
0helpful
1answer

Someone stole the face to

contact the manufacture the should have the part
6/3/2011 6:53:16 PM • Power Acoustik... • 117 views • 0 helpful votes
Not finding what you are looking for?
Power Acoustik PTID-8960 Car Video Player Logo

Popular Tags

20 questions posted

Ask a Question

Usually answered in minutes!

Top Power Acoustik Car Audio & Video Experts

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Power Acoustik Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Power Acoustik Car Audio & Video

  • Power Acoustik Car Audio & Video

Most Popular Question

ptid 8960 dvd player gps but when

  • Car Audio & Video
Loading...