20 Most Recent Whirlpool Cabrio WTW6600SBT Top Load Washer - Page 2 Questions & Answers

it sounds like the water pump is not emptying properly, blow down the water outlet pipe to see if is clear if not go to the water pump and clean it out there is probably a button , paper clip or other debris preventing it from doing its job eric

Apparently it's a common fault (among others) with this brand/model of washer; as Whirlpool has dedicated a page to it. How to clean the interior of your washer to remove odors

Sounds like a blockage between drum and pump or outlet water hose to drain,or the pump needs replaced

You may have something like screws or nail or something that was in some ones pocket or just fell into the tub . You may have to take the agitator out to get it out unless you can get something under it to get it out. This is pretty common I've seen nails get in a hole & wear a hole in the drum , then you have a leaking drum. Not sure but sounds like this may be your problem. Hope this helps good luck

Sounds like a control board problem

Most likely actuator is not engaging into spin mode or yellow pulley has come loose and not engaging or slipping.

Model # please?

My dryer did the same thing, it was so distrubing noise in the middle of drying cycles, so I turned off the sound switch it went away, now it doesn’t peep any more.

In many cases the spinning motor is problem.

Bite the bullet and tell him, its a lot better to get him or somebody who knows how to do the work than to make it worse or destroy it all together figuring it out. The drum comes out pretty easily, but definitely not a process I would feel comfortable walking someone through

LF Long Fill
If the water fill time exceeds ten minutes, the water valves are turned off and LF is flashed.

That sounds like the gearbox has gone bad, I've replaced several that were doing the same thing and were still under warranty

Dl means there is a door lock problem.

If all obstructions are removed, and still doesn't drain, replace pump.

So when you say it's not pumping all water out, is there still water standing in tub or no water standing and clothes are just sopping wet? Is machine spinning? If not spinning, could be actuator that shifts transmission from agitate to spin.