20 Most Recent Maytag EPIC MFW9600S - Page 10 Questions & Answers


Check the door switch to make sure that it is not loose. If it is not loose, it may have failed.

Maytag Washing... | Answered on Jan 26, 2019


USUALLY IT HAPPENS WHEN THE TRANSMISSION DOES NOT SHIFT INTO FINAL SPIN WHICH IS HI SPEED COULD BE CONTROL BOARD OR THE MOTOR ITSELF A REPAIR SERVICE MIGHT BE THE ONLY RECOURSE THERE IS . SORRY

Maytag Washing... | Answered on Jan 26, 2019


OMG. So much blathering BS. I just fixed this by unplugging the machine FROM THE WALL for 20 minutes. Put the plug back in. Low and behold. Door unlock, everything reset, all is well.
Grow a brain people - just reboot ????....

Maytag Washing... | Answered on Jan 25, 2019


Remove the belt from the pulley under the machine.
check shaft and thrust bearing for damage. If good, go back to top of machine and take out the agitator.
check shaft splines for condition in agitator and shaft, if all ok, rotate shaft with slip pliers or the like and if you rotate it and get grinding noise your transmission is bad and needs to be replaced.
my thoughts are the 1980 machine has had a good life and it's time for a new machine.
Good Luck,
Gary

Maytag Washing... | Answered on Jan 24, 2019


Could be a number of things. Belt, control board, door lock, bearings.

Maytag Washing... | Answered on Jan 19, 2019


tub capacity of my LAT 9804 top load washing machine?

Maytag Washing... | Answered on Jan 11, 2019


The door lock is stuck or the pump hasn't removed all the water and freed the catch. Try disconnecting the power by flipping the breaker and counting to 10, and turn back on again.

Maytag Washing... | Answered on Jan 08, 2019


Sadly, this sounds like a bad transmission in the washer. Unless it is a newer, high-end washer, fixing it is probably not going to be cost effective. IMNSHO, based on experience, once a major breakdown like this occurs in an appliance, other major failures aren't usually far behind. If it isn't still under warranty, get a new one :/

Maytag Washing... | Answered on Jan 03, 2019


Depends on what you have to do get water to shut off. If cutting off at faucet is only way, then replace valve.

Maytag Washing... | Answered on Jan 02, 2019

Not finding what you are looking for?
Maytag EPIC MFW9600S Logo

54 questions posted

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

jimorris77

Level 3 Expert

411 Answers

Sheldon Dedek

Level 3 Expert

909 Answers

Bill Long

Level 3 Expert

606 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Maytag Washing Machines

  • Maytag Washing Machines

Most Popular Question

problem f02 error

  • Washing Machines
Loading...