20 Most Recent
Kenwood KDC-MP235 CD Player - Page 3 Questions & Answers
My stereo have a problem when i am opening it the
First, if you can, check your speakers and speaker wires for shorts and/or grounds. If they check out fine, press the reset switch, it should be a small indentation about the size of a pencil tip and will not be marked. If that doesn't work, you may have a bad output ic.
10/11/2011 5:10:37 PM •
Kenwood...
•
Answered
on Oct 11, 2011
Got in car this morning
Hi.
Protect mode is a special condition that kicks in when an internal fault has been detected. In protect mode all the unit function are disabled to prevent the stereo getting more damage in consequence of the fault. The state is a forced standby condition that starts when a wrong voltage or a short is detected.
Try disconnecting the battery terminal, pulling the radio out of the dash and checking the wiring at the back of the stereo. Most of the time protect mode is triggered by a wiring contact. If possible check also speaker wiring. A contact in wiring to speakers will trigger protect.
Regards.
Ginko
9/14/2011 11:59:38 AM •
Kenwood...
•
Answered
on Sep 14, 2011
Ken wood car music system
codecs are diferent try burning the cd with another software like alcohol.... maybe you should adjust the speed of recording.....
8/23/2011 3:39:23 AM •
Kenwood...
•
Answered
on Aug 23, 2011
I NEED A MASTER CODE
Your code number is 5227 (KCAR) As set by Kenwood unless changed by the purchaser.
If different then check the link below for excellent tip?
As posted by robotek (Below), Regards.
http://www.fixya.com/support/r538828-security_unlock_code_kenwood_most_models
6/8/2011 11:44:10 AM •
Kenwood...
•
Answered
on Jun 08, 2011
My radio keeps saying "Protect"
First make sure your speakers and speaker wires have not shorts or grounds. If they all check out good try pressing the reset switch (usually a small pencil tip sized indentation on the front of the face or behind the face on the sub panel. If it still reads protect after that, you may have a bad output ic.
5/17/2011 6:34:15 PM •
Kenwood...
•
Answered
on May 17, 2011
I just hooked the cd
check all of your speakers and speaker wires for shorts, grounds or bare wires.
2/23/2011 5:27:24 PM •
Kenwood...
•
Answered
on Feb 23, 2011
Need Unlock Code for Kenwood MP235 car stereo
Look for a really small hole in the face plate. Put a tip of a pen into it. Press it in and then it should turn on. If this doesn't work, take it to a place that installs them, they'll help....Usually for free....
2/20/2011 11:57:25 PM •
Kenwood...
•
Answered
on Feb 20, 2011
Not finding what you are looking for?