20 Most Recent Technics SL-BD22 Turntable - Page 7 Questions & Answers

The cueing mechanism should lift and lower the tone arm regardless of whether there is oil in the cylinder or not. The silicon oil is used to dampen the movement. If the lever does not operate the tonearm, then there is mechanical damage under the platter.

Were you expecting an electronic powered unit to work without power ... No power = No output.

Question edited for spelling and add some SPACES! Did you look for bulging electrolytic capacitors? If you can't see any, then you need to take it to a service centre, as they have thousands of dollars of test equipment and access to parts. ..

Probably dirty contacts in the tone control section.

See the Equipment Connections section of user manual at page 3 to 10. Connecting accessories are given in detail there. Equipment Connections Sa-Ex300 - Technics SA-EX100 Operating Instructions Manual [Page 5] ' ManualsLib

Are you sure that model number is correct? It looks like they should have 4 numbers.

Technics SA-5570 Service Manual

You need Wiring Schematic, or Block Diagram or Service Manual. https://www.google.com/search?q=Technics+SA+E570+wiring+schematic ..

Unfortunately you can't. It does not support MP3 format.

you can but it will not work.

Check the pinch rollers it could be old and need of replacement.Also might be the belts.

To be honest most people simply replace the keyboard than try and fix them. They are not expensive. You could have a problem with the driver for the keyboard, so you could update it. That's worth a try before chucking the keyboard!

there is no reset

It may have overheated. Some have small internal fans. Also vacuum any cooling slots. are the side or rear. Turn it off for a couple of hours but also removing the mains plug to reset. https://www.google.com/search?q=Technics+SA-GX500+overload There is no official Reset Procedure. https://www.manualslib.com/manual/485502/Technics-Sa-Gx550.html#manual ..

Pro Logic cannot be decoded from a non Pro Logic source.

If the front panel display on your Technics SA-AX6 is not turning on even though you have replaced the display board and verified that the ribbon cable is not broken, there may be an issue with the power supply or the main control board. It's possible that a component on one of these boards has failed, preventing the display from receiving power or a signal. You may need to take the receiver to a professional repair shop for further diagnosis and repair.

It doesn't look like you can. It states at the bottom of the remote it is 'pre-programmed'. That means it was made the Television and VCR combo only. https://www.google.com/search?q=Technics+remote+RAK-SA60+to+Technics+stereo+SAR-177

TECHNICS SAR177 Replacement Remote Control

https://www.remotes.net > products > replacement-remo... The RTEUR64775 is a custom-built replacement remote control to the original TECHNICS SAR177. It will perform all the functions that the original TECHNICS ... US$34.90 ..

you can google Technics PCM Sound EX10L manual copy and paste https://www.manualslib.com/manual/899941/Technics-Sx-Ex10l.html ..

Unplug, take off cover (6 screws). Locate the POT at back of volume knob. At wire lugs spray some Deoxit contact cleaner in cracks. Move knob back and forth a few times. Replace cover n try it??

Help in the link https://www.google.com/search?q=technics+sa-dx750+f70+error ..

Some help here, but likely connections not in the right place. https://www.google.com/search?q=Aiwa+PX-E860+connected+to+Technics+ST-HD560+has+no+sound ..