20 Most Recent
Sharp AR-5320 Black and White Copier - Page 8 Questions & Answers
Set password ar5516
press and hold light key until all red lights blink and enter 11to add new user code and start button to set .to exit press lighter key.
Error u2-40
EEOROM read/write error (serial communication error) or toner chip diseble
What is meant by f2 ?
In my experience, F2 codes generally refer to the developing unit. The Crum chip at the back could be faulty or simply, the unit isnt quite sat right. I would recommend removing the unit and re-seating it. Hope this helps.
Error code h4
use the simulation code.... #,int,c,int, then enter 14 then press copy key.... sometimes it works... but if not... you may change the following like heater lamp
Ch code
How about asking a question? It makes thing so much easier.
What is the meaning red light like a sun
hi your copy machine is indicating to replace developer or try reset it . if the copy is clean just reset it it will work for no. of copier. how to reset (c intrupp # intrupp ) then 42 sub code 01 hope it will help u.
thank You
Sharp ar 5520 fault code
F2 40 = ATC sensor abnormality
Check e remedy :
Remove/Install the toner cartridge again.
Replace the toner cartridge with a normal one.
Driver windows 7
Try this - http://www.sharp.co.uk/cps/rde/xchg/gb/hs.xsl/-/html/support--downloads.htm
Sharp AR-5320 Driver
Hi,
Appreciate the direct "Ask Me". For Sharp AR5316/AR5320 drivers, pls click
here. The drivers are for Windows 95, Windows 98, Windows ME, Windows NT, Windows 2000, Windows XP only.
Just a start, do postback how things turned up or should you need additional information. Good luck and Thank you for using FixYa.
Not finding what you are looking for?