Cleaning & descaling your Keurig brewer is an important step to enjoying the best tasting coffee and keeping your brewer in good shape for years. 4 Comments 2
How often you need to do it depends heavily on how often you use your brewer and how "hard" your local water is ("hard" meaning how many minerals are in it). I try to do this 3-4 times a year. Comment Recommended For You 3
Open the top of your brewer and remove the K-cup holder. CAUTION: There's are two sharp needles in there. Be careful. Comment 4
The cup holder is dishwasher safe. You can toss it in the dishwasher if you want. Otherwise a good rinse under warm running water is usually good. There's a sharp needle in here, so be careful. Comment 5
Turn the cup holder over and ensure these holes at the bottom are free of any obstruction. Comment 6
The drip-tray is removable. Give it a good clean either by hand or in the dishwasher. Comment 7
The upper portion of the K-cup holder also has a needle. This needle has three holes in it. Insert a straightened paper clip into each hole to remove any buildup or obstructions. 1 Comment 8
Here's a close up: There's nothing you can break in here, so use some force and get that paperclip a good inch in and wiggle it around vigorously. Repeat this for the two other holes in the needle. 1 Comment 9
Use a damp, soft cloth to wipe away any coffee grinds or water stains in and around the cup holder area, and down the front of the brewer. Comment 10
Be careful of that needle inside when wiping it down. Comment 11
Put the K-cup holder back in the chamber. Make sure it's the right way around by aligning the arrows at the top of the holder. Comment 12
Empty the water in the brewer's external reservoir. 2 Comments 13
Refill the reservoir with undulated white vinegar and replace on your brewer. 1 Comment 14
Run four large cup brew cycles. DO NOT use a K-cup, just run it empty . Dispose of the hot vinegar after each. This pushes the vinegar through the inside heating tank as well as all the valves inside. 2 Comments 15
Leave your brewer to stand, powered on for four hours. This allows the vinegar time to break down any build up in the tubes and valves inside the brewer. 1 Comment 16
Discard any leftover vinegar then refill the reservoir with water only. Comment 17
Run large cup cycles until "Add Water" is displayed on your brewer's screen. This washes out all traces of vinegar from the insides of the system. Comment 18
If you notice a vinegar-like smell or taste to the water coming out of your brewer, refill the reservoir with water a second time and run hot water cycles until empty. 3 Comments 19
Congratulations!! Your Keurig brewer is now clean and your ready to enjoy full cups of delicious coffee for months to come! 3 Comments
1,052 questions posted
Usually answered in minutes!
1,392 Questions
725 Questions
453 Questions
366 Questions
296 Questions