20 Most Recent Keurig Platinum B70 Coffee Maker - Page 7 Questions & Answers

You need to purge the system. Clean the upper needle port with a paperclip end. Stick it all the way up the tube and into the reservoir. That will allow water and air to push out from the chamber. Make certain the Water Filter is changed. Blow out the tube from the lower water container with Canned Air. Always use Distilled or Filter water as city water has too many minetrals that collect inside of the heating chamber.

I would try turning over and try the "Burp" method to release an air pocket. Can search on u-tube for this video and how to.

There is a Black Rubber washer you can get at the Home Depot cheap that comes in a pack of 5 or so maybe a couple of dollars where you can use one with the factory rubber washer to boast it up some. We use one with our Keurig B70 that stopped the leaking. There is a video on YouTube someone made which I believe the person tells you the washer size you need to get. With the electrical problem you have if you knew the wire was ripped you should of delt with it before hand instead of taking a chance with it. Being it probably grounded out and possibly burnt up the wire you may of blew up something inside the unit. I would repair the wire first or replace it but it may need more then just electrical tape if any of the 2 leads in the double strip wire going into the unit is touching the other. After doing your repair plug it in to see if the unit will light up. If it does you should be good to go. If it doesn't you may need to take the unit apart to see if there is a fuse inside the unit. If there is it is probably burned out and you will need to pick up a new one at a Radio Shack or other electrical part supply store. I would look for further burns inside the unit but it should of stopped at the fuse if there is one inside the unit. Good Luck. I give you credit I don't throw anything away until I can check it out further. People throw too many things away that don't really need to be thrown out and take only pennies to fix with a little knowledge. Vacuum Cleaners are one of the many.

Most of the time, the operation is working OK, but the flow lines get plugged. When they have debris in the lines, the unit keeps on trying to work, but the water cannot move through the lines. The cycle will run its course nevertheless. Clean the top and bottom ports (Needles) with a paperclip end. Make certain the filer is changed often, and purge now and again. Use filtered water or distilled and this will not happen.

The PRIME is important. If you looses the prime, you cannot lift the water up and into the reservoir for heating and eventually flowing to the Kcup and beyond. Full the Water container all of the way to the line (not over), prime as per the manual, with the handle fully engaged, see if that fixes the problem.

Hi,

Here is a tip that I wrote that will give you some things to try that will helpyou get your Keurig coffee brewer workingagain.

Keurig CoffeeBrewer not making a full cup of Coffee
heatman101

;'';
][\[]\

Page 17 in manual has instructions

Purge and blow out the lines. Debis is in tubes and ports.

Pad and Circuit board shorted. Return for replacement.

Timer is not their best suite and the 2014 systems are far better.

See page 17 of the manual for directions on purging system.

Return for replacement. Factory problem. Many have experience this condition.

Internal debris from manufacturing need flushing. Descale will help.

You are wasting your money as a replacement Coffeee Maker is only $99 Vs $80 parts.

Circuit boad may be defective if the wall power is operational. Return for replacement.

Heater may be defective and factor repair is the answer.

Seals worn, need new ones.

Seals damaged and need replacing.

Call 1-866-901-2739 Parts.