20 Most Recent
Pyle PLTDN71 Car Video Player - Page 8 Questions & Answers
I want to wire my 4 ohm DVC subs to my Pyle 3000 watt home receiver amp
No you don't. You'll fry the amp. You need a low frequency processor to strip the mid and hi frequencies out of the signal applied to the subs or you'll have a full frequency sub that will sound cruddy. If your amp outputs 8 ohms the you'll have to wire 2 speakers in series or poof goes the amp. If the amp is only 16 ohms then you're out of luck unless you have 2 more speakers to connect in series to the 2 you aleady have.
How to reset your pyle Astor
If there is no reset button behind the faceplate (usually small and either black or sometimes red ) Press it and hold it down with the tip of an ink pin for at least ten seconds , when you release it it should have reset your unit. If you don't see the reset button , just disconnect the power wire (red) and 12 volt constant power (yellow) for about 10 seconds as well. That should do it ! Good luck !
Not finding what you are looking for?