20 Most Recent Jabra BT125 Headset - Page 6 Questions & Answers

Press and hold for about 3-5 seconds, the blue light will flash on. Make sure the headset is fully charged.

Go to this site, and it will walk you through each step to connect your particular Jabra headset with your Nokia E72. Choose the headset, and then at the next page, choose your phone. Moving your mouse over each step will change the picture to what you should be seeing on your phone at each step.
http://jabra.pairx.co.uk/ Pls come back and let us know if this solved your problem.

The headset doesn't 'do commands', it only communicates your voice with your telephone. If you telephone is equipped with hands-free dialing, then you can hands-free dial through the headset. You can only use features which were originally installed on your phone through the headset. Please advise if this answers your question.

The Jabra goes into discovery mode when the unit is off, and the power button is pressed for ten seconds, which passes the five second power on time.
At ten seconds the unit lights constant to state discovery mode is on.
See the manual on Pairing:



To download the PDF of the Manual click here. This is page 6.

Please provide your location country, state, place i might search it for you on net

taken from the manual found at

http://www.jabra.com/sites/Jabra/GNimages/Products/WirelessHeadset/BT125%20Black/Documents/User%20manual/BT125_UM_NA_EN_471.pdf

1. Put the headset in pairing mode
• Make sure the headset is off .
• Press and hold the answer/end button until a solid blue light comes on.

2. Set your Bluetooth phone to ‘discover’ the Jabra BT125
Follow your phone’s instruction guide. This usually involves going to a ‘setup,’ ‘connect’ or ‘Bluetooth’ menu on your phone and selecting the option to ‘discover’ or ‘add’ a Bluetooth device.* (See example from a typical mobile phone in fig. 3).

3. Your phone will find the Jabra BT125
Your phone then asks if you want to pair with it. Accept by pressing ‘Yes’ or ‘OK’ on the phone and confirm with the passkey or PIN = 0000 (4 zeros). Your phone will confirm when pairing is complete. In case of unsuccessful pairing, repeat steps 1 to 3.

0000 is the original pass key

Go to makers website anlook for support. You can likely download the owners manual .

pass code is 0000 dont forget send me result

Hi,

First you have to enable the Bluetooth to scanning mode,
To do this, press and hold the power button continously for 10 seconds, you may have a stable LED, this shows that its in discoverable mode, Now perform scanning and you may get your device and you can pair and make it work
The default passcode may be 1234 or 0000 or 8888


ENJOY! RATE THIS SOLUTION
RNJ VINOD KUMAR

It is either a faulty charger or a Defective or Non Working Bluetooth.

Try using 0000 for a code as it is the standard code for most bluetooth device, unless changed.

you have to turn it off then press the button until it flashes continuously then you can look for it with the blue tooth in serch devices then just pair it with code 0000

Hold down the power button until it becomes a steady blue light. This should put it in discovery mode

1234

yes ..you can use 0000

let fhone searts for bluethooth device and select the device then you can give connection code 0000 and connection wil be working

I think that you're referring to the Bluetooth authentication key. This is a 4-digit value that is typically set by the manufacturer to be "0000". Sometimes it is "1111" or "1234".

Just switch on the power button and hold it till the blinking light remains on continuously. Then this is in discoverable mode.

it is usually four zeros