20 Most Recent Plantronics CS55 Wireless Headset - Page 2 Questions & Answers

Reduce speaking volume by changing the speaking volume
major adjust switch setting. See page 15 in the User's Guide (link below).
• Point microphone towards your chin.
• Listening volume too high on phone. If your phone has a handset
volume control, lower this until the distortion disappears.
• If the distortion is still present, lower the listening volume adjust
button on the headset. If the distortion persists, select another
listening volume major adjust switch setting. See page 14 in User's Guide.
• Base is too close to computer or phone. See page 9 in User's Guide for
proper positioning.

For further help, this is the link for the Plantronics Wireless Headset User's Guide.

Good luck from Headsets Direct!

Lowering the ring volume on the phone only decreases the sensitivity of the lifter, which generates the signal to the headset. The signal volume between the two is preset and cannot be adjusted.

Good luck from Headsets Direct!

On your base there are the numbers 1-4. Put the # 1 in the 3 O'Clock position like a clock. Try putting the letters that are in the bottom on B.

Good luck from Headsets Direct - 800-914-7996.

If you click on the following page:

Plantronics CS55 Wireless Headset

Towards the bottom of the page, click on the tab labeled ADDITIONAL INFORMATION. Within that section, you will see PLANTRONICS CS50/CS55 INTERACTIVE USERS GUIDE to click on. This will help you visually see how to setup and start using your CS55.

Good Luck from Headsets Direct!

Hi there,
what program are you using to speak to them Skype, Yahoo Messenger, etc.?
What operating system are you running, you also have to make sure that the microphone is set up.

Hi! Yes, wireless devices can cause interference on other wireless devices. The devices are normally defaulted to channel 6 (as are wireless routers). If you have the ability to change channels on these devices, change the channels to 1 or 11. also if you have the transceivers too close to the phones themselves, this can also cause interference and that echo you are hearing. Good luck.

You will need the Plantronics HL10 handset lifter in order to have the CS55 ring, indicating an incoming call. The HL10 also allows you to answer remotely on most phones and hang-up remotely.

Plantronics HL10 Handset Lifter

Good Luck from Headsets Direct!

Hello, you can download the manual here: http://www.plantronics.com/us/media/media-resources/literature/user_guides/73156-01_CS55_US_DL.pdf?WT.dl=20 It says that a flashing amber light means charging, a solid amber light means charged, a solid red light means power, a solid green light means talking, and a blinking green light means muted.

try doing a system reset press the call control button and the volume mute button at the same time for 5 seconds. when the talk indicator light blinks release both buttons. press the call control button again and the talk indicator light will blink again briefly headset is back to normal then unplug the charger from the charging jack for 5 seconds and plug back in headset is reset. if that doesnt work then replace the battery in headset.

We're had customers call with similar issues. First, make sure your compatibility dial is set properly (located on the side of the base). If set incorrectly, it will make your headset inoperable. If that doesn't fix your issue, try disconnecting and reconnecting the battery and then perform a subscription. Both steps can be found below:

How to Replace your Plantronics CS55 Battery
How to Subscribe your Plantronics CS55 Headset

Good Luck from Headsets Direct!

The first thing to try is resetting the CS55. We hear this a lot and once reset, it usually takes care of the problem. It's equal to a ctrl+alt+del on a computer. Click on the following for detailed instructions and photos:

How to Reset your Plantronics CS55 Wireless Headset

Good Luck from Headsets Direct!

I dont owe one.

http://www.retrevo.com/support/Plantronics-CS55-Headsets-manual/id/908ag611/t/2/

to solve this problem on the left side of the base there is a inset dial that has 1-4 around it turn it so it points towards the number 2 this should make the headset beep when recieving calls.