20 Most Recent La Crosse Technology Wireless Temperature Station 9013 - Page 2 Questions & Answers


Battery compartment contains reset button. Press. Will need to re-enter time and date.

https://www.acurite.com/kbase/weather-stations/02031RM_Weather_Station.html

Measuring Tools... | Answered on Sep 10, 2019


Place your remote temperature sensor and the inside unit together for about an hour to see if they both read the same or if there is a large difference in the temperatures.

Dashes on the outside temperature reading may indicate that the inside unit is not receiving a signal from the remote. Change the batteries on the remote or change the location of the inside and/or outside units so that they can receive a strong signal between each other.

Your smartphone temperature may be coming from a location that is not near your home. They are often from a weather service. Where is your local temperature sensor located? Is it in the sun? Is it on the south side of the house, or another location where the sun or an air conditioner or other heat source may affect the accuracy of the reading? Try to locate your outside sensor in a shaded location with plenty of ventilation, and away from heat sources.

Measuring Tools... | Answered on Sep 07, 2019


Do you have a setting for the power line frequency? Some devices get their timebase from the power line frequency and if your powerline is 60 Hz, but you have it set on 50 Hz, then it will speed it up because of the 10 extra cycles per second.

Measuring Tools... | Answered on Sep 07, 2019


The sensor should flash briefly when you put in good batteries. Afterwards it should flash about every couple of minutes. If you have a voltmeter check the batteries are at least 1.3 volts (the voltage will drop when they get colder). Ideally they should be about 1.4-1.6 V. Try cleaning the battery compartment contacts and springs with a cotton bud and alcohol. If the contacts look rusted then use fine emery paper or scrape with a screwdriver to remove the rust and tarnish. Clean the ends of the batteries by rubbing with a tissue or cloth. When inserting new batteries twist them inside the battery housing to help make better contact. Another thing you might try is to use a screwdriver to very carefully stretch the springs in the battery compartment a little to allow better contact. (Warning do not pull the spring too hard so as not to damage it) If using new batteries does not help then the sensor may have a fault. If the led on the outdoor sensor is flashing but the indoor sensor does not pick up the signal you can try putting the indoor sensor closer to the outdoor sensor. Otherwise you may need to re-tune the indoor sensor to the correct frequency (there is a small adjustable screw inside).

Measuring Tools... | Answered on Aug 31, 2019


last four of phone no.

Measuring Tools... | Answered on Aug 24, 2019


Radio Frequency communication may come and go occasionally. This can be normal in some environments (e.g. moister climates). If transmitter signal is lost, please wait 2-4 hours for the signal to reconnect on its own.

Here is a link to the User Manual for your product.
https://www.lacrossetechnology.com/media/catalog/product/w/s/ws-8119u-it__faqs_1.pdf

Measuring Tools... | Answered on Aug 18, 2019


Hi Bogdan.
i think the LCD is not good.
if it is possible to replace it???

regards.
nuwan

Measuring Tools... | Answered on Aug 15, 2019


try new test leads first. even if the unit is miscalibrated, you should get the same measurements from the same components/circuits. you'll need to send the unit to a calibration center, or the manufacturer, to get it zeroed out, if you still need to afrer getting new test leads

Measuring Tools... | Answered on Aug 13, 2019

Not finding what you are looking for?
La Crosse Technology Wireless Temperature Station 9013 Logo

4 questions posted

Ask a Question

Usually answered in minutes!

Top La Crosse Technology Measuring Tools & Sensors Experts

Cindy Wells

Level 3 Expert

6027 Answers

Brad Brown

Level 3 Expert

18108 Answers

ka4iup
ka4iup

Level 3 Expert

4062 Answers

Are you a La Crosse Technology Measuring Tool and Sensor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

La Crosse Technology Measuring Tools & Sensors

  • La Crosse Technology Measuring Tools & Sensors

Most Popular Question

changed batteries in both indoor display

  • Measuring Tools & Sensors
Loading...