20 Most Recent Motorola Mobility H350 Wireless Headset - Page 6 Questions & Answers

on your phone open your bluthooth section and(1) turn on bluetooth. then in the bluetooth options, (2)have your phone ready to search / find devices. (3)on the h350 press and hold the power button for about 5 seconds until the blue light comes on and stays on. it is now in paring mode. (4)tell ur phone to search for devices. your phone should find it. (5)then select the h350 on your phones found devices list. they will now pair. its possible a password will be requested, i believe the factory default password for the h350 is 1234. your phone password may be the same as your phone unlock code or your voicemail code.
time is limited you may have to do this a couple of times before they actually pair together.

you need to buy a new one then! or use warranty!

0000

press and hold the power/ answer button on the 350 until the blue light comes on and stays on. once it is solid blue its in paring mode.

Most headset PINs are 0000. Try either that or 1234.

push and hold the power button

Motorola uses 4 zeros for all.

try 0000 or 1234.

You are trying to connect your bluetooth to your computer using a USB cable? For what purpose? You can charge it that way in theory but is there something else you were trying to do?

The honest answer is i doubt it. The chances of it working as it should again will be about 80/20 against in my experience. The problem is the water will short out parts of the electronics that aren't meant to be connected damaging them for good. All you can do is remove any battery and leave it to dry out in an airing cupboard or somewhere warm. Replace the battery and try it. If not then sadly you will need a replacement.

go to connections - search for devices - select the device - the passkey is 0000

0000 is the default passkey

0000 is the default passkey for the Motorola headset

default is 0000

Yes,
It should work with your ps3. Here is a link with all the steps for connecting a bluetooth headset to a ps3.
http://boardsus.playstation.com/playstation/board/message?message.uid=26900460
Thank you,
Lee

Hello,
you have to put it in pair mode. basically with the device turned off, press and hold the pwer button until the blue light remains steadily lit. then you can search for the device from your phone. the passkey should be 0000. good luck.
Thank You For Using FIXYA!!!!

the default one is 0000..

after you hold the button in and it flashes 2 or 3 times it is off

passkey is of ur choice..
only remember that it must b same on both..
it can consist of a single digit to 4/6/8 digit(s)..
eg: if i u type '0' as ur passkey at ur bluetooth tp..u gotta give '0' to ur ph also..

very easy..
try to seek professional advice of ur system admin/vendor....

Turn your Bluetooth on Go into your phone go to tools. Choose Bluetooth, then choose options go down to add new, then you will have 2 choices and choose searchand the devices will and and then the should work