Top 20
Samsung CLX 3160fn All-In-One Printer Questions & Answers
Reset factory setting
Dear
Go to tech mode -menu + # + 1934. in sequence within 4 sec.
press menu go to TECH MODE press enter. scroll for display DATA SETUP-enter- scroll for mem.clear.
Thanks.
How to clean glass on samsung clx-3160fn
Ok to clean glass get tough and do not wreck the machine, sounds bad but damage could occure if your not careful but forceful.
1)down load any faxes not printed or sent to your computer
2)turn unit off with power button
3)inside of paper exit opening in the upper left hand side push green slide lever towards the back of the machine,,this locks the scanner carage(you can also see the green lock through the scanner glass to the left of the scanning carage as you move the lock). I did this not to disturbe the scanning carage while cleaning the glass.
4)the lid to the scanning bed has to be removed by lifting the complete tray to it's limit and unplugging the data cable,,it is in the middle between the hinges(pinch the cable connector plug locks on both sides and pull out the connector. To release the rectangular hinges lift and tilt the complete unit further back toward the rear of the printer/fax machine. It should lift out and REMEMBER that rear tilt when replacing the fax/printer feed unit as the hinges don't just slide back in to the respective holes.
5)there are two screws near where the hing holes are on eather side of the scanner cover they must be removed.
6)NOW this is the tricky part with only your hands no tools,,,with a large amout of force lift the back corner of the scanner cover(this does not seem possable but lifting at the side of the machine the cover does have a slight lip to lift with and it makes tearable sounds of distruction BUT IF you lift each side near the rear upward for about 1/2inch at a time(side to side)"2 INCHES ONLY" total the cover will give enough room to CAREFULLY reach your hand under the scanner cover with a damp rag to clean the glass and dry with a lint free rag(micro fiber rags work). I used no cleaners at all but lint free is the ticket. DO REALIZE THE TRAY ONLY LIFTS UP ABOUT 2 INCHES from the rear and it should stay up at the 2 inch hight. The removal of the scanning cover would mean more dissasembly of the unit and I saw no need to go that far.
6)NOW to replace the scanner cover (hopefully you were carefull enough not to crack or break the glass as lifting unevenly or pulling upward more than 2 inches could be the end to your scanner. The trick to get the cover back down with the registration tabs into thier respective holes,,it helps to pull outward on the sides of the plastic body where the tabs have to drop down into,,the large taps at the rear are a little less co-operative but with a bit more force the back body will seperate slightly and the read pins fall into place.
7)put the screws back in, then the scanner cover hinges first and snap the data cable into place,,Don't forget to slide the scanner lock (green tap)towards you to unlock the scanning tray.
Good Luck, it sounds difficult and it might be but it can be done without damage. I'm sure a true service repair man would not like the method but my machine is near it's final useful days.
How do I turn off the printer?
The power button is located at the back of the printer on the lower right side (when facing the printer), it's a flat horizontal toggle switch right near the communication cable connection for the printer.
The toner cartridges need an aggressive action to remove or install but with care making sure the alignment tabs are properly centered.
What is the waster toner container
hi,waste toner container is the printer after the printing balance taransferbelt toner image is wiping & then store the printer tank this is the waste tank or toner waste container
Samsung CLX-3160N Document jam Scanner Error
the printer samsung clx 3160nprinter to check the any papper part .to clear the papper jam then will be the adf scaner sencer hang.so you can change the adf paper senser or correct fix the senserliver. best wishes
NEED DRIVER TO INSTAL THE PRINTER
Check the drivers of your printer on the manufacturer's site whoever the manufacturer of your printer is. On the site go to download, select your printer type or printer model name or no.. and then click search for the respective drivers. And on seeing the respective drivers click for download.*** You can also visit our website
http://www.vtechsquad.com for the further technical assistance related to your electronic and network gadgets.
HOW TO UNLOCKED THE SCANNER
Please check for scanner lock from paper exit area. else this may be related to hardware.Also refere the user manual in detailed.
Samsung CLX 6220
one reason the door cant close is precisely because there is a pastic piece on the door itself that prevents it from doing so, the reason is because the belt is most likely in the wrong position... it may need to have a lever moved to have it stay up and then closed. check the green handles and try turning them to different positions
Not finding what you are looking for?