20 Most Recent Polaroid i733LP Digital Camera - Page 8 Questions & Answers

read the ininstruction on putting it all on default,,,,,,,,,,,,

Hey susanfiscus,
You should have it looked at by an authorized service technician. You could contact the manufacturer and they should have a list of authorized service technicians in your area, and if they don't they would then most likely be able to provide you with an address to mail your camera into an authorized service center. You could also bring the camera into a Geek Squad® precinct in a Best Buy™ store and they should be able to send it out to an authorized service center. As far as how much it would cost depends on both what is wrong with the camera which can't be known until it is looked at by a technician. I will also say if the camera is less than a year old the repair could be covered under manufacturers warranty and no cost to you. I hope this helps!

Sincerely,
Allan
Go Ahead. Use Us.

If it landed on the nav key it may have broke the chipboard it sits on but it maybe just out of line try to get to the board and see if the rubber slip is out of line if it is fine you can take it to most camera shops and get it repaired

Hey brigando,
What is most likely wrong with the camera is the LCD screen is damaged and needs to be replaced. I would bring it to an authorized service center and they should be able to give you an estimate on the repair. I hope this helps!

Sincerely,
Allan
Go Ahead. Use Us.

Use the viewfinder to take pictures on vacation, then have your camera looked at in a camera shop or repair shop to assess the damage. Might be cheaper to just get a new camera sometimes with labour costs and parts costs these days, but doesn't hurt to get it looked at for free!

I have been having these same problems and after i read all of your problems with no sure answer I logged onto polaroid.com call the support number and they said if i have the recipt they will send me a new one!!! try it and good luck

First, do you know what cord you are using to connect? For me, I use a SanDisk connector, where you put the memory card right into t he devise.

Hi-

You can download the driver from this link just click HERE
Pls rate as fixya if it helps, thanks!

well...i am currently goin through this process right now...see mai camera fell from about 5 feet on to racks...it still looks brand new...but don't know what to do...i suggest you find ur reciept and take it in to the place u bought it from or the company...

there wil a cam settings in side ur camera... enter that settings and turn on ur flsh light..

if my solution is helpful means vote my ratings....

IS the flash in auto mode? You can manually turn off the flash in the menu, itll look like a lightning bolt with a slash through it. Flash will not operate in macro mode if available. no other firmware problems I can think of would stop firing the flash, might be hardware/defect.

yes

Sounds like a power problem. Recharge the supplied LiOn battery. Clean terminals and contacts with a pencil eraser.

If this fails, return it.

im gonna give an example first ( if u turn ur camera on and dont do anything it will power off) so go to ur menu were u set stuff up and c if theres a spot were u set power on\off time and if its below a minute put it on a minute or higher i recomend a minute though so if it turns on in ur purse it wont run the batteries down if that doesnt work and ur not using lithium batteries try thoughs if thoughs tips dont work send it in to the company so if it is really messed up and instead of sending it in to the company u have a electronics store work on it and the camera is like half way fried or something and you had a peron that doesnt work for your cameras company work on it the company will take it back and give u a new 1 cause on the warranty it states that if u have a person that doesnt work for the cameras company work on it and they didnt think it was ur fault the camera was messed up they would give u a new 1 but like i said if u have someone that doesnt work 4 that company they wont give u a new 1 so b careful

I got this camera or christmas .Worked good for awhile. Screen went purple and now its not working.

My daughter just had this problem with her camera. The camera was off with the lens barrel extended. When I looked at it closely, I noticed that the inner part of the lens barrel was at a slight angle to the camera. I pushed firmly on the low side of the inner part of the barrel, and it popped the rest of the way out. Camera works fine now. Good luck!

I am having the same problem

i have the same camera and i just changed the batteries and it worked.but now the lens is stuck out and it will not turn on.

This can sometimes be fixed if you remove the batteries over night and allow the camera to sit and discharge it should correct this problem. hope this helps.

Hello, here is a link to download driver for i733 LP.
http://www.polaroid.com/service/software_download.jsp?PRODUCT%3C%3Eprd_id=845524441765978&FOLDER%3C%3Efolder_id=282574488338994&bmUID=1206674314753&bmLocale=en_US
Hope this helps. Good Luck.