20 Most Recent
HP LaserJet M4345 MultiFunction Printer - Page 3 Questions & Answers
How to assign ip address for laserjet M4345 when it is reset at 0.0.0.0
1 Press MENU.2 Touch CONFIGURE DEVICE.3 Touch I/O.4 Touch EMBEDDED JETDIRECT MENU or EIO JETDIRECT MENU, depending on which type ofnetwork connection you are using.5 Touch TCP/IP.6 Touch CONFIG METHOD, and touch MANUAL.7 Touch MANUAL SETTINGS8 Touch IP ADDRESS9 Touch the left arrow or the right arrow to highlight each segment of the IP address.10 Use the numeric keypad to type the digits in each segment of the IP address.11 Touch OK to save the IP address.
Hp 4345 has error code 13.20.00 paper jam in tray
The printer may need a "swing plate" replaced to solve the fuser noise. Remove the fuser and look at the black gear inside the printer on the left side. Do the teeth on that gear look worn ? If so that gear (swing plate) needs to be replaced. Its a hard job to do. Can you turn the fuser gears with it out of the machine without them skipping ? The tray 2 jam may just be worn rollers in tray 2 or a stuck sensor. Good luck !
Cold reset
when powered off the printer, press 3 and 6 and hold, power on, make your choice at menu, (cold reset) and press ok. printer will restart itself.
HP M4345xs MFP Unable to load paper from tray 2
Hello Robert,The normal cause of not being able to pull paper from tray 2 is worn out paper pickup rollers. You can pull out the paper tray and look inside the opening the opening to see the rollers on the right hand side. Here is a picture of the rollers.
The end of the roller has a little clip to press to release the rollers from the shaft. If you remove them and check the surface you will probably find then to be smooth, they should have a surface like a fingerprint to grab the paper. The rollers come in a kit called RK-4250 that included the rollers for tray 1 and tray 2. The RK-4250 is available here:
http://www.ccl-la.com/catalog/product_info.php?products_id=302 Replacing the rollers should bring the printer back to full use. Be sure that when you replace the rollers that you puch them back on the shaft until they click into place.I hope this helps you get your printer going,BuddyMc
Grinding noise
"Swing plate assembly" (RM1-0043-020CN) need to replace to avoid grinding noise. ..Note: Only professionals can perform this activity..
Not finding what you are looking for?