Sylvania LC320SS8 32 in. LCD Television - Page 5 - Answered Questions & Fixed issues

0helpful
1answer

I am unable to locate my owners manual and need to

First, go into your setup main menu and rescan for available channels - here is the manual link too - http://safemanuals.com/brand-user-guide-instructions-owner-manual/SYLVANIA

Best Regards,
Beach TV Repair
7/4/2010 9:28:58 PM • Sylvania... • Answered on Jul 04, 2010 • 485 views
0helpful
1answer

Cannot turn my LCD TV

You will have to do some checking inside the TV if you are going to DIY.
If you are going to DIY and have proper tools and know safety precaution then please read on:

Please see my basic troubleshooting guide here:
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide

http://s807.photobucket.com/home/budm/allalbums

http://en.wikipedia.org/wiki/Capacitor_plague

Parts: www.shopjimmy.com
7/4/2010 2:15:49 AM • Sylvania... • Answered on Jul 04, 2010 • 132 views
0helpful
1answer

What are the best picture and audio settings for a

Go into tv menu go to PICTURE go down to reset u should get the tv in Factory setting,that the best reconmended settig for the tv.The sound setting put in stereo.The Power Saving put in advanced,should used less,save about 20% less power comsumming.
7/3/2010 11:22:23 PM • Sylvania... • Answered on Jul 03, 2010 • 463 views
0helpful
1answer

No picture does not turn on,fuse is good

Need to check voltages next.
If you are going to DIY and have proper tools and know safety precaution then please read on:

Please see my basic troubleshooting guide here:
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide

http://s807.photobucket.com/home/budm/allalbums

http://en.wikipedia.org/wiki/Capacitor_plague

Parts: www.shopjimmy.com
7/2/2010 9:22:23 PM • Sylvania... • Answered on Jul 02, 2010 • 281 views
0helpful
1answer

My tv will not turn on the power light flashes but

good day . your tv has a defect . maybe i the main board causing not to switch on the power. just go to the sevice center to fix your problem
7/10/2011 8:36:50 PM • Sylvania... • Answered on Jul 10, 2011 • 319 views
0helpful
1answer

Hdmi

You need to lower your video source resolution, it is too high for the TV to display. PS3?

http://s807.photobucket.com/home/budm/allalbums
http://en.wikipedia.org/wiki/Capacitor_plague
6/18/2010 6:40:49 AM • Sylvania... • Answered on Jun 18, 2010 • 472 views
0helpful
1answer

I have a sylvania 32 lcd that will not turn on the

Hello, this can be fix but know that Ur power supply board is dead, u know basic electronics’ and soldering? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up on it top.Replaced these gases leakages capacitors will get ur tv power stable,and work again.Or tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.
Hope this helps...
2/20/2011 4:35:49 PM • Sylvania... • Answered on Feb 20, 2011 • 1,200 views
0helpful
3answers

Controlling my Sylvania LC320SS8 with my Dish Network remote

Try these Sylvania codes: 10054, 10030, 10171, 0030, 0054, 0171, 1944, 1963.

These weren't listed in Dish Receiver manual.
6/12/2010 4:58:47 AM • Sylvania... • Answered on Jun 12, 2010 • 2,786 views
0helpful
1answer
0helpful
1answer

Won't come on power on light flashes then goes back to standby mo

Hello,
Normal 0 false false false MicrosoftInternetExplorer4 st1\:*{behavior:url(#ieooui) } /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;} Ur power supply board is dead, u know basic electronics’ and soldering? Most of the times, the power suppply board just have dead leakages gases capacitors.These capacitors alway bulges up on it top,or puff up on it top.Replaced these gases leakages capacitors will get ur tv power stable,and work again.Or tries websites like Shopjimmy.com,Ebay.com to buy a whole rerfurbish power supply board for the replacement.

11/29/2010 5:32:10 AM • Sylvania... • Answered on Nov 29, 2010 • 721 views
0helpful
1answer

My sylvania ld 320ss8 flashes

it shows a screen of blue, then a screen of red and then other colors? It may be in demo/service mode. Not sure of the key combination to exit this mode...
4/21/2010 6:21:35 PM • Sylvania... • Answered on Apr 21, 2010 • 1,026 views
0helpful
1answer

Where can i order sylvania lcd tv parts

encompassparts dot com.
4/20/2010 6:24:57 AM • Sylvania... • Answered on Apr 20, 2010 • 145 views
0helpful
1answer

I have a sylvania tv and i just bought a living

Code scan remote to see if another brand code will work, other wise you'll need a different remote that was made after the TV was made.
3/15/2010 5:41:58 AM • Sylvania... • Answered on Mar 15, 2010 • 156 views
0helpful
3answers

My tv will not pwr up. grn light flashes then turns red.

I have a Sylvania LD320SS8A and I turn it on and the green light comes on and no picture???? Just black... I can hear some sound but no picture...
4/25/2010 10:37:20 PM • Sylvania... • Answered on Apr 25, 2010 • 2,661 views
0helpful
1answer

Sylvania LC320SS8 32 in. LCD Television - Will not turn on

U have power on 10 mins,than is not the power supply board.Ur Tuner board is dead replaced that board.Tries websites Shopjimmy.com,Ebay.com to buy a refurbish tuner signal board.
2/9/2010 4:52:45 AM • Sylvania... • Answered on Feb 09, 2010 • 1,090 views
0helpful
1answer

Turns on and turns off immediately

The caps (capacitors) in the powerboard are going out. This is a very common problem in all class and price ranges of modern lcd and plasma tv's/ monitor's. I don't know if this problem has been like this for awhile or it just started, but either way, if the tv takes an abnormal amount of time to "warm" up then it most likely will go out all the way sometime in the (near) future. If you have a tiny bit of will and knowledge ypou can open the unit and get to the print board. Examine this for "popped" capacitors, they will have a buldging top instead of a flat one. Im gonna try to include a pic of them here, if i can get it this time, I've tried bfore lol. But you can google image a "popped" or "bad" capacitor and you would be able, with ease, to diagnose if you have any of these. Usually only one or two. Radioshack sells capacitors (couple anyway) for $1.59 each. MAKE SURE the replacement is of the SAME voltage or HIGHER, or you will be right back replacing those 2. Every capacitor has a negative pole marked with an (-) on the side of the capacitor(by one of the "legs", always puit the negative (-) "leg" of the new capacitor in the same hole in the printboard as where the previous negative (-) "leg" of the capacitor was ( a capacitor with the negative and positive "legs" put in backwards will result in the new piece "popping" as sson as you turn it on!!) make sure the "uf" rating (for example the most common popped capacitor is the 1000 uf) is the same as the one you are replacing. I needed 1000 uf, 105 c and 26v (volt) ratings for the 1 capacitor I needed to replace to fix my LG 19" lcd panel monitor I found by the trash that the light came on off, but it didn't come on. I replaced that capacitor with ; 1000uf, 85 c and 36 v (volts0...It works fine eventhough the volts and the temperature rating (36v and 85c) was not the same as the (26v(volt) and 105c ) capacitor I removed !! Further, I've replaced capacitors that had the celcius rating of 105 with the only ones Radioshack had, namely 85 c(celsius) they have been working great, but I'm not sure about any effect, nor have I heard or read (yet?) about that making an urgent difference. Many threads that I've read people have done the same, so we should be ok (my stuff has been running good for a while longer then most brand new ones!.............(all these ratings ; 'uf ' and 'c' etc are on the side of the capacitor you are replacing and on the side of the ones you are replacing them with)...For all this all you need is the cheapest solder gun u can find (I bought one for $7.99 at Radioshack), a camera (to take pictures as you go to remember how to reassemble the unit) and, once you have your materials, 20 minutes to replace 2 or 3 capacitors and you are good to go...Most monitors and tvs (lcd/plasma) I've seen you have to lay flat on the ground/bed/blanket etc, to work on (screen side down). Usually there are 2 or 3 screws (or a few more) to remove, then you will have to carefully (its comes off easily most times)insert a flat screwdriver inbetween the casing and gently pry it up as you go around the whole frame. Sometimes you have to remove the little washer arouind the cable input orso, just be gentle and you cant go wrong. Once insidet here will be a box with wires running to the sides etc...unplug, gently, these wires and open the box. Inside you will find 2 or 3 circuitboards, check them all for "popped" capacitors, replace, reassemble and plug it in....Have fun becoming an overnight tv mechanic lol!

Please rate if this was usefull to you (and I know your tv symtoms by heart)...Thank you!
2/2/2010 8:46:51 AM • Sylvania... • Answered on Feb 02, 2010 • 762 views
0helpful
1answer

In my Sylvania LD320SS8 A the picture is beeing

If you have a cable box attached to the tv, check the "aspect ratio" on the cable box. there should be a button on the remote for the cable box. this may solve your issue.
1/31/2010 6:53:07 PM • Sylvania... • Answered on Jan 31, 2010 • 895 views
0helpful
1answer

WHEN USING HDMI INPUTS,WHY DOES T.V. SHOW FORMAT

Ok, there are differing HDMI "Standards" not all TV's play/use all HDMI "Standards". Please have a look at this WiKi it explains far more than can be done here.
http://en.wikipedia.org/wiki/HDMI
1/22/2010 8:31:20 AM • Sylvania... • Answered on Jan 22, 2010 • 798 views
0helpful
1answer

I have a sylvania lcd tv [ lc320ss8] when i turn

Did you get your problem fixed? Mine just started doing that yesterday. I can not seem to find out how to fix it.

1/11/2010 6:13:43 PM • Sylvania... • Answered on Jan 11, 2010 • 444 views
0helpful
1answer

I need a remoto control for lcd 32 tv

you should be able to get one from Funai they made your set and they have a good website or try mr remote
1/8/2010 8:35:33 PM • Sylvania... • Answered on Jan 08, 2010 • 118 views
Not finding what you are looking for?
Sylvania LC320SS8 32 in. LCD Television Logo

294 questions posted

Ask a Question

Usually answered in minutes!

Top Sylvania Televison & Video Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

matt martin
matt martin

Level 3 Expert

1259 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you a Sylvania Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...