20 Most Recent
Xerox Phaser 6110 Laser Printer - Page 9 Questions & Answers
What is a engine sensor on a Xerox phaser 7600
Unfortunately, your sensor failure will require a replacement from a Xerox technician. You will have to call Xerox or the company you purchased the equipment from to get this resolved.
best way to describe it would be to compare to a cars engine, if your starter fails to work the engine won't run, same for your Xerox device the sensor tells the engine to run.... :o(
This is a major hardware failure on your device.
Vignette printing problmes on xerox 550
It's a bit since I last saw this problem.
I would need a lot more detail to get to the bottom of your problem.
if you have been able to print out the Vignettes before then you can eliminate software, firmware & print driver.
You might have a problem with the laser units, black/cyan or magenta/yellow, the window underneath could be dirty.
If all this is a bit too daunting then you got to get hold of Xerox.
Sorry,
Goodluck.
What does a second transfer bias roll do
It simply drives the transfer belt which is required to lay the image down on the paper.
Depending on which Xerox product you have would depend on whether a service tech is required to replace one that has failed or whether it is a roller that can be easily replaced by a non tech saavy individual.
I hope this helps...
Phaser 8860 prints only on left side of the paper, leaves perfect image on drum of right side.
Dear
As per your statement the image formation on drum is ok but prints partial on paper.
The image from the drum is picked by ITB (Inter Transfer Belt) which is a thin plastic like material and the paper passes in between the transfer roller and ITB.
If the ITB unit is not properly aligned to the transfer roller or to the drum the problem will occur as you mentioned. Also check the transfer roller and it contact path.
Thanks.
Not finding what you are looking for?