20 Most Recent
LG 50PC3D 50 in. Plasma Television - Page 2 Questions & Answers
Shorted q18
check value of caps in power supply they tend to dry out. do to heat.
Tv come on then shuts off
Does the power light blink after it shuts down? The number of blinks will usually indicate which area is failing. Most plasma tv's fail due to YSUS and Y buffer board failures.
T.v. won't turn on
Bad caps in power supply,Crack or splits on top of cap or leaking, Check value of caps in power supply.
Power won't turn on
hi, there could be few components that might have failed, it might be best to look for a tech in your area, as you will need a multimeter service manual to help you
regards
shaun
Turn on and red light go to green and back to red
These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit stage inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power led, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating, to many popular brand TVs and other devices. Viewing it in "
Mosaic" will make surf easy.
http://electronicshelponline.blogspot.com/
Blinking codes details to many popular brand TVs are given.
POWER SUPPLY CAPACITORS
Look on ebay for power supply capacitor kit for your model. Range from $20 to $30..some even have soldering irons. Replace all caps paying attention to polarity. This will clear lots of sets that don't power up.
Wont turn on when u press on off button it just goes click click clickc
Go to EBAY and look up a capacitor repair kit for your model kit. They cost $20 to $30. This is to fix the power supply board which is the middle board. Be sure to note polarity of the capacitors you replace. There is a positive and a negative on them and that must be observed. Use a magic marker and mark the top of each cap as you replace it. Replace all caps supplied in the kit even if old ones don't look puffed out. This should fix your power supply. I did this on a friend's set over a year ago and the power supply is still ok.
TV won't turn on at all, totally dead.
Check and replace its main power supply regulator board as card basis. Normally, there is no repair to these boards of plasma TVs. Any attempt to repair this board, will result both waste of time and money. And more, after replace this board, you have to adjust the Vs & Va voltages, according to the plasma panel label too. In fact, replacing this board is not a silly work for a user to proceed. It will be best to contact any service technician. If you wish to get some details; check the site linked here. Viewing it in "
Mosaic" will make surf easy.
http://electronicshelponline.blogspot.com/
Not finding what you are looking for?