HP LaserJet P3005n Printer - Answered Questions & Fixed issues
HP P4014n How to change default tray
The reason it isn't pulling from tray 2 which automatically is automatically the default tray is because the pick up rollers are bad. Replace them and you will be all set.
7/25/2021 7:16:13 PM •
HP LaserJet...
•
Answered
on Jul 25, 2021
•
1,369 views
50, 4 FUSER ERROR
50.4 is not listed in the service manual but fuser errors are most often caused by bad fuser. Occasionally a power supply or DC controller will fail but seldom is that the case.
8/20/2014 5:05:25 AM •
HP LaserJet...
•
Answered
on Aug 20, 2014
•
133 views
I am getting problem with
Printer error code "49.4c02" is one of them. It occurs when there is corrupted data. This may confuse the printer, and it stops functioning. In other cases, the data is corrupted while being transferred to the printer. Some printer models are naturally prone to this error because of their driver, while others can display this error while printing a specific font.
http://www.fixya.com/support/t6031482-hp_laser
8/4/2014 10:39:54 AM •
HP LaserJet...
•
Answered
on Aug 04, 2014
•
584 views
HP laserjet p3005d frozen on "download file now send rfu upgrade"
Need further information as there are several ways this can go, some of which are fairly complicated. Does the screen state Download firmware over USB? or Resend over parallel port?
Post the exact message and I will see if I can find you the tech document that shows the steps needed, depending on what the screen says.
7/2/2014 4:50:19 AM •
HP LaserJet...
•
Answered
on Jul 02, 2014
•
625 views
Registration clutch
Here is how you do it: http://www.lbrty.com/tech/Manuals_HP/P3005sm.pdf
6/16/2014 3:14:14 PM •
HP LaserJet...
•
Answered
on Jun 16, 2014
•
81 views
Print smears on right edge of paper only
It is possible that the fuser film is damaged. The fuser film covers the heating element. Open the back panel, and examine the area where the paper exits. The grey film should cover the same area as the lower black roller. If not, you will either need to replace the fuser or obtain a replacement fuser film and install it. Is the printer noisier than it used to be? The fuser bushings on these printers are notorious for wearing out and causing the film to fail. If the bushings are worn then likely a replacement fuser will be the solution for you.
5/24/2014 5:55:41 AM •
HP LaserJet...
•
Answered
on May 24, 2014
•
83 views
55.00.00 DC Controller error
Basically The engine is not communicating with the
formatter.
1. Turn the device off and then on.
2. Verify that the flat ribbon cable between
the ECU and the formatter PCA is
connected correctly.[do extra care while removing from board easily crack at ends]
3. If the message persists, replace the
ECU[check on board and track,component damaged-burned its fixable].
If the message still persists,replace the formatter.{before replacing it can be fixable by hot oven/hot plate method }
inquiry send on
http://electronicdoctor.weebly.com
formatter
ecu
4/3/2014 9:55:37 AM •
HP LaserJet...
•
Answered
on Apr 03, 2014
•
2,657 views
Not finding what you are looking for?