Top 20 HP LaserJet P3005n Printer Questions & Answers

Do a factory reset then reconfigure device one more time.

The reason it isn't pulling from tray 2 which automatically is automatically the default tray is because the pick up rollers are bad. Replace them and you will be all set.

Did you try to open and close the toner door after you closed the rear bin?

all prints are blank or print 1 page after every print job?

According to the service manual this is a sub cooling fan error. This fan is on the left side of the printer.

Need further information as there are several ways this can go, some of which are fairly complicated. Does the screen state Download firmware over USB? or Resend over parallel port? Post the exact message and I will see if I can find you the tech document that shows the steps needed, depending on what the screen says.

50.4 is not listed in the service manual but fuser errors are most often caused by bad fuser. Occasionally a power supply or DC controller will fail but seldom is that the case.

Basically The engine is not communicating with the formatter. 1. Turn the device off and then on. 2. Verify that the flat ribbon cable between the ECU and the formatter PCA is connected correctly.[do extra care while removing from board easily crack at ends] 3. If the message persists, replace the ECU[check on board and track,component damaged-burned its fixable]. If the message still persists,replace the formatter.{before replacing it can be fixable by hot oven/hot plate method } inquiry send on http://electronicdoctor.weebly.com formatter ecu

tIpically streaking on P3005 is related to the toner cartridge. First I would try replacing the cartridge. If that doesn't resolve it the next more likely cause is a fuser. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/charles_45d8d6c78cd9f0b6

Here is how you do it: http://www.lbrty.com/tech/Manuals_HP/P3005sm.pdf

It is possible that the fuser film is damaged. The fuser film covers the heating element. Open the back panel, and examine the area where the paper exits. The grey film should cover the same area as the lower black roller. If not, you will either need to replace the fuser or obtain a replacement fuser film and install it. Is the printer noisier than it used to be? The fuser bushings on these printers are notorious for wearing out and causing the film to fail. If the bushings are worn then likely a replacement fuser will be the solution for you.

Hi lenka, I suggest You Go to Official HP Printer Page For You HP Printer Problem On Below Hp forum URL Link: Fixing Blinking Lights In Case You Still face Problem and Need Online Assistance Then Please Follow Us For On : HP Printer Support

change bush and gear set.

You have a pick up roller that needs replaced. If you pull the tray out, take a flashlight and look up into the printer. You will see a black roller. It probably is covered with white paper dust and slick looking. This needs replaced. That is all that is wrong.

You can get the service manual here: http://www.ccl-la.com/images/pdf/HPP3005.pdf

which rollers are you reffering to, feed rollers,, or fuser rollers, or image transfer rollers etc etc?

Buen dia un favor, tengo un aimpresora hp laser 2410 y me sale error 57,03 me podrian haer el favor y me colaboran? GRACIAS.

Re-seat the fuser. You must have it in a bind...either than or the new fuser is defective.