20 Most Recent HP LaserJet P3005n Printer - Page 4 Questions & Answers

Your prinyter has a "laser/scanner" problem. The "laser/scanner assembly" probably needs replacing. A trained tech should check it out.

49.XXXX errors are commonly firmware problems. Go to www.hp.com/support/LJP3005.Click Download Drivers andSoftware. Check for the latest firmwareimage version at the bottom of the page.If this firmware image is newer than theone installed on the device and thedevice can receive a firmware update,download the newer firmware upgrade

The actual error says that the hard drive is bad. I bet that you don't have a hard drive on your printer, so read on...From the manualNVRAM initializationCAUTION Initializing the NVRAM resets the serial number, the event log, the page counts, andthe EIO card (initializing the NVRAM resets SERVICEmenu values to factory defaults). Use theservice menu to restore the serial number and page counts. Also reconfigure any computers thatprint to this device so that the computers can recognize the device. Initialize the NVRAM onlywhen absolutely necessary. In most situations, use a cold reset rather than a NVRAM initializationto reset device settings (this will retain the values in the SERVICEmenu).NOTE Before performing a NVRAM initialization, print a menu map and a configuration page. Use the information on the configuration page to resetany customer-set device configuration values that the NVRAM initialization procedure changes.Take special note of the total page count, maintenance count, and the serial number.1. Remove any installed accessories.2. Turn the device off.3. Turn the device on. When the memory count begins, press and hold the button. Continueholding down the button until all three device control-panel lights flash once and then remainon. This might take up to 10 seconds.4. Press the button.5. Press the Menubutton. The display should show SKIP DISK LOAD.6. Press the button until NVRAM INITis highlighted.7. Press . The device initializes NVRAM and then continues the power-on sequ

Go to the "Resets" menu and select the "RESTORE FACTORY SETTINGS" selection. This will revert your machine to the condition that it was in when it came from the factory. Remember, the default for networking is DHCP, so once reset and online, you could use the web interface to configure it further.

Go to www.hp.com/support/LJP3005.Click Download Drivers andSoftware. Check for the latest firmwareimage version at the bottom of the page.If this firmware image is newer than theone installed on the device and thedevice can receive a firmware update,download the newer firmware upgrade. Try printing a job from a differentsoftware program. If the job prints, goback to the first program and try printinga different file. If the message appearsonly with a certain software program orprint job, contact the software vendor forassistance. If the message persists, contactHP Support

you don't need to clean it. you have to change the film inside the fuser

INR 9000/- in india...

Paper length mismatch.. select proper length matched to tray selection..or else in printer menu select paper length as any size..

Verify is there DIMM in slot?.. replace with same part no.If no DIMM in slot replace formatter.

Formatter malfunction, remove & refix all the connectors..check flat cable connectors got damaged? replace itreplace formatterreplace dc controller.

Paper path sensors dusty, clean all paper path sensors as well as verify sensor flags & springs..

Can cell all pending que jobs.Reload the drivers..Update the firm ware.try with different portreplace formatter

Are you selected manual path while shooting the data?Check tray 1 paper sensorIn printer menu settings select as always from tray1.. try it I hope it will solve the issue.

Might be askew codes. Check through which port it's printing?..Try with different port.Cancel all Que jobs.check with another data cablereplace formatter