Top 20
Hitachi 42HDS69 42 in. Plasma Television Questions & Answers
Why do I get a "No Sync. Signal" note when I attempt to use my DVD player on Input 2?
Depending on the TV model, there were some where the IR (Infrared) board inside the TV failed. It is not the remote that failed. You can test the remote by trying it at a Best Buy store on some of their TV's. If you are somewhat handy, you can easily remove the IR board and send it into a repair service that I located on E-Bay. There was repair service in Indiana and one in California. I sent it to the California and it came back in less than 1 week. I installed it and the TV works fine now.
My hitachi tv is dead
Fault with the main power supply regulator board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
http://electronicshelponline.blogspot.com/
It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size.
Hitachi ultravision is hot, to the touch, Is there concern?
I've owned a 42HDX99 since 2007, It's always been warm/hot. Still works/looks Awesome. Plasmas do generally run hotter than
LCD/LED's. Also have a 58" Samsung Plasma ( which I've had to repair ) and a 2009 Toshiba 1080P LCD ( still works great )
Hitachi plasma popping a fuse
Fault with the main power supply regulator board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
http://electronicshelponline.blogspot.com/
It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and precious time. This is true, especially to Plasma TVs.
Hatachi power button
Hi, I have the same problem , tries to fire up but doesnt seem to get enough power and cuts back to off. Ihave been told its a capacitor that is failing...These are very cheap to buy but its a daunting thought to change it myself
HDMI inputs not working
Go to its service mode option, and check whether HDMI port software are installed, and activated. To get more detail about how to activate service mode, h
ttp://electronicshelponline.blogspot.com/ check this link.
Pull up previous posts there, either by its left side bar,
or view it in Timslide option.
Base tv
To make it understand, you must have its repair manual downloaded. Try to download it. It has illustrations about the disassembley. If you wish to get more details, check the site linked here. It has disassemble procedure to many brand TVs with illustrations.
http://electronicshelponline.blogspot.com/ Pull up previous posts there, either by
type in the Brand name to your set in its search box, or view it in
Mosaic
/ Timeslide / Flipcard option.
Not finding what you are looking for?