20 Most Recent HP Deskjet D2360 InkJet Printer - Page 7 Questions & Answers

Hi,

Check if the printer is located under

Start-->Control Panel--->Printer and faxes

If the printer is not found in this location; then drivers are not installed correctly and you may need to reinstall them.

Reply back, if there is any issue


Regards
Riztech

You can install the printer by downloading the software from this link and use it to install to your computer.

http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?lc=en&cc=th&product=1100995&dlc=en

Contact the dealer and replace the paper tray///

clean the rubber rollers of your printer they might be too dirty that causes the improper movement of paper and cause the paper jam..or open the cover of your printer check for the brocken belts .or paper rollers

Download updated driver from:
http://h10025.www1.hp.com/ewfrf/wc/softwareDownloadIndex?softwareitem=dj-76773-1&lc=en&dlc=en&cc=us&os=4062&product=1100995&sw_lang=

Go to the maintenance section of your printer on your desktop and clean the cartridges

Start - printers or Start - control panel - printers

Also check the level of your ink while you're there

http://filespump.com/hp-deskjet-d2360-service-manual.html

Hi there

Take a look in the manual it can only be you need new ink or there is a bit of paper sticking in it some where.
All the best Pineworks

You can go to the HP support site page here:

http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?product=1100995&lc=en&cc=us&dlc=en&lang=en&cc=us&submit=Go%20â»

Pick your OS and download what you need.

Here's the link ....


http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?prodNameId=1101015&lang=en&cc=us&taskId=135&prodSeriesId=1101113&prodTypeId=18972

select your OS from the list

Go to the link below then select the operating system of your computer.

http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?product=1100995&lc=en&cc=us&dlc=en&lang=en&cc=us

I hope this helps!

Click on the link below and choose your operating system and download the driver. Run the downloaded software while the printer is not connected and most HP software will tell you when to plug the printer in.
http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?product=1100995&lc=en&cc=us&dlc=en&lang=en&cc=us&submit=Go%20â»

It is problem in mechanical.May be any paper stuck or any sensor displace.So you need service your printer.Keep your mind green lid blinking mean printer busy.also check printer black cartridge.

Make sure you are installing the printer with the latest drivers available for your version of vista. See here for available downloads. Or run MS update after you connect the printer.
If you are getting some particular error message in conjunction with the installation, see here.
Finally, review the installation instructions for your printer available here. In general, make sure you install the latest software BEFORE connecting the usb cable, and do the latter only when prompted by the installation wizard....

I hope this information allows you to resolve this issue. If you need further assistance, please post back with a comment to this thread.
If I've managed to answer your question or solve a problem, please take just a moment to rate this post....thanks!

Here a link to the HP support site http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?product=1100995&lc=en&cc=us&dlc=en&lang=en&cc=us&submit=Go%20» Choose you windows version from the list
You will then be presented with a list of drivers for your printer - click to download the file onto your PC and once saved - find the file on the PC and double click to install - then follow the instructions - DO NOT connect the printer to the PC until asked to do so

Click here for your drivers and follow the on-screen instructions.

“All lights blinking and printer not responding” is indicative of serious ink cartridge issue. Usually when this happens the printer fails to goes through the motions of the printing process, kind of stands still with indicator lights just blinking away. This could be as a result of either of these scenarios.
i.                     Ink cartridge has developed incompatibility or is incompatible
The Solution is to try an older/another cartridge (doesn’t matter if ink is finished. You must replace cartridge one at a time). If lights stop blinking it confirms that your cartridge has become incompatible or developed incompatibility. Also if your printer is the type that can work with only one cartridge, remove one after the other (closing back the lid/cover) to determine which in the set (black or color) has become incompatible. At the instance the incompatible one is removed and you close the lid, the blinking will stop (for printers that can print with one ink cartridge only). Just replace the incompatible one and start printing again. In most cases the issue is always with one cartridge. But if both are affected, you have to replace both. Because of this type of problem, always keep used cartridges somewhere safe; they come in handy for this type of troubleshooting.
ii.                   The Cartridge electronic panel  is dirty
The electronic panel on the cartridge that makes contact with the cartridge carrier inside the printer is dirty and needs cleaning.  This electronic panel is front part of the cartridge with copper “dots”.
The Solution is to try to clean this panel with a piece of folded tissue paper soaked in a bit of methylated spirit. Also try to clean the area in the cartridge carrier/holder that makes contact with the cartridge’s electronic panel (Usually this is more difficult). If you cannot reach it with your fingers, use a stick or something with tissue wrapped around it. Allow to dry well and return the cartridges, close the cover. The blinking should stop if the electronic panel is the issue. Once the blinking stops the printer will print.

CHANGE LANGUAGE SETTINGS IN XP

it might be because cartage door might be left open, else a hardware defect, need to visit service center

Hi
Try this link to get free download

Thank you