20 Most Recent Nikon N60 35mm SLR Camera - Page 3 Questions & Answers

kmarcum,
Take the camera off auto focus,if the shutter fires and you can manually focus, then the lens must be repaired. Take the lens to a camera repair shop and get an estimate.

It really depends on how much you like the camera!

The cost of repairs can vary, but a high-street dealer can be quite expensive, over £100 is quite common, and if replacemnt parts are required this quicky becomes very expensive.

You may be able to find a less expensive repairer somewhere like eBay, but it may be less expensive to buy a used replacement from an internet vendor.

It's quite shocking how cheaply some very nice caneras can be bought for!

Make sure it comes with a warranty though. Three months is typical, and is usually long enough for you to properly test the replacement. If it does not break after three months of normal use, then it's likely to last a long time. (One's offered without a warranty may not even have been properly checked.)

Also make sure that the seller specialises in photographic gear, and is well established. It's quite easy to look real professional on a internet auction site right from the word go. So look for evidence that the seller has been doing this for a while and regularly, and check any scoring system the site provides.

As a final note. Don't go for the cheapest vendor. I sell and repair cameras professionally, and you can take my word for it that you cannot provide a proper level of after-sales support and sell good cameras for next to nothing. These things take time, and time as they say.....

It's probably the lens.

The gears become worn an a little sloppy, and also sopmetimes a little stiff.
This makes them overshoot the correct focus and then they have to try again resulting in the hnting you describe.

There can be other problems, but this is the most likley. Try another lens and see if you get the same problem.

On Nikon cameras the ON/OFF button is more of a safety-catch for the shutter that a power button. Does it correctly disable the shutter button when turned to OFF?

Check your lens aperture ring setting. It must be set on the highest number I.E. f16,f22,f32..

Hi,
Replace the battery maybe weak.

Set f stop ring ( aperture ring ) on the lens to highest F stop number ( 16 ) and lock in position. This will get of fEE massage.

Lock the f stop ring on your lens to f 22 or f 16. This will get rid of fEE

If your lens is set to F/22 or the smallest available on your lens, this is not a user problem. Take it to your local camera repair shop ( usually $100 to $125 repair to phase or sequence switch ).

It sounds like your Nikon FM may be experiencing a mechanical issue with the shutter mechanism. Here are a few troubleshooting steps you can try:

1. Inspect the Film Advance Mechanism: Check the film advance lever and mechanism to ensure they are functioning properly. Make sure there are no obstructions or debris interfering with the movement of the advance lever.
2. Check the Shutter Release Button: Inspect the shutter release button to see if it's sticking or malfunctioning. Sometimes, a stuck or sticky shutter release button can cause the shutter to fire unintentionally.
3. Examine the Mirror Mechanism: Carefully inspect the mirror mechanism to see if there are any visible signs of damage or misalignment. If the mirror is flipping up unexpectedly, there may be an issue with the mechanism that controls its movement.
4. Clean and Lubricate: If the camera hasn't been serviced in a while, it's possible that dirt, dust, or dried lubricant may be causing the issue. Consider cleaning the internal components of the camera and applying a small amount of appropriate lubricant to the moving parts (be cautious and follow proper procedures when lubricating a camera).
5. Seek Professional Repair: If the issue persists after attempting basic troubleshooting, it's advisable to have the camera inspected and repaired by a qualified camera technician. They can diagnose the problem more accurately and perform any necessary repairs or adjustments to restore the camera to proper working condition.
6. Use a Different Lens: Sometimes, issues with the lens can affect the camera's operation. Try using a different lens to see if the problem persists. If the issue only occurs with a specific lens, there may be a problem with that particular lens.

It's essential to handle the camera with care during troubleshooting, especially when accessing internal components. If you're unsure about performing any repairs or adjustments yourself, it's best to seek professional assistance to avoid causing further damage to the camera.

Have you tried fresh batteries and setting the shutter speed dial to M90 or m250 whichever you have? If this does'nt work you can remove the camera bottom plate and gently pull a lever away from the advance cog. Some times things get out of sync in there. Sorry I can't be more specific but I did this many years ago. Good Luck.

There are youtube videos on this type of repair to DSLR cameras and I dont recommend that you try it unless you have incredible talent for small details and a very clean environment.

On many cameras, a lens error means the lens is not set to is highest f/stop such as f/16 f/22 and the like. The lens must be put in that mode for the camera so that the camera electronics can auto set the f/stop as needed. First thing I would do is look at the f/stop on lens with manual f/stop settings; such as the Nikon 50mm f/1.8D making sure it is set to the highest f/ number (smallest opening). Remove the lens check the dial. Also, is the battery fully charged? If all that is okay then do the following couple of things; 1. Get yourself a film change bag, they look like a black plastic/rubberish T-shirt. Put the camera in there make sure the bottom is fully closed, put your arms through the sleeves, they have elastic keeping light out. Open the camera carefully remove the film canister then using your fingers rewind the film back into the canister. 2. Okay, you do not have access to a film change bag, easy get a thick blanket or two, go in to a closet, close the door, put a towel at the bottom, cover your camera as best as you can then do the same as if you were using a change bag. Important, make sure you are in a completely dark place without ANY LIGHT working its way through to you. Next, being as your are using film, big congratulations for that, purchase a change bag from Adorama, Amazon, B&HPhoto. Every film shooter should have one. Hope the above helps you.

That is likely a job for an experienced repair technician, not for DIY.

Does the shutter operate when the back is closed? (In other words, does it expose the film?) If so, don't worry about it. If not, it may need service -- or it may be set at such a high shutter speed (1/2000, for instance) that makes the shutter open and close so quickly that you can't see it move.

if it takes a button battery replace it, or check for fungus growth (yes it happens) within the viewfinder.

Nikon 4 Instruction Manual