20 Most Recent
Jensen 143307 Remote Control - Page 4 Questions & Answers
I lost my code booklet
1.Manually turn on the component you want the remote to control.
2.Press
and hold the component key (TV, VCR, Etc..) you wish to program. The
illuminated ON-OFF key turns and remains on.
3.While holding the
component key down, press and hold the ON-OFF key. The illuminated
ON-OFF key turns off.
4.After holding down both keys for three
seconds, the illuminated ON-OFF key turns back on.
5.Release both
keys. The illuminated ON-OFF key remains on.
6.Press and release the
ON-OFF key repeatedly until your component turns off. Wait four seconds
between each keypress. Each time you press the ON-OFF key, the
illuminated ON-OFF key blinks and the next code in the list is sent.
This process continues until all of the codes in the Code lists have
been searched. If your component turns off, you have found the correct
code.
7.Once you have found the correct code, you must save the new
code by pressing and releasing the STOP key. The illuminated ON-OFF key
turns off. You must press the STOP key to save the code or the correct
code will not be stored.
hope this helped
Robb
please leave feedback
How i can program my remote jensen jer 622
Try the following steps.
1. Turn on the tv
2. Press and hold the "tv" button. The light should turn on and stay on.
3. While holding the "tv" button down, press and hold the on/off button. The light should go off, but if you keep holding the buttons, it will turn back on.
4. When the light turns back on, release both keys.
5. Press and release the on/off button repeatedly (while pointing the remote at the tv) until the tv shuts off.
6. As soon as the tv turns off, stop pressing the on/off key and press "stop." This will save the code that controls your tv.
7. If you wish to program your remote to other devices (vcr, dvd, etc.), use the same process described above, except turn on the device you want to control and press the component button that corresponds to the device, rather than "tv." For example, if you want to program your remote to a vcr, you press the "vcr" button instead of the "tv" button, as in the instructions.
I hope this helps!
Sincerely,
Der Strom
Jensen JER321 3-Device Universal Remote
coding:
1.Manually turn on the component you want the remote to control.
2.Press and hold the component key (TV, VCR, Etc..) you wish to program. The illuminated ON-OFF key turns and remains on.
3.While holding the component key down, press and hold the ON-OFF key. The illuminated ON-OFF key turns off.
4.After holding down both keys for three seconds, the illuminated ON-OFF key turns back on.
5.Release both keys. The illuminated ON-OFF key remains on.
6.Press
and release the ON-OFF key repeatedly until your component turns off.
Wait four seconds between each keypress. Each time you press the ON-OFF
key, the illuminated ON-OFF key blinks and the next code in the list is
sent. This process continues until all of the codes in the Code lists
have been searched. If your component turns off, you have found the
correct code.
7.Once you have found the correct code, you must save
the new code by pressing and releasing the STOP key. The illuminated
ON-OFF key turns off. You must press the STOP key to save the code or
the correct code will not be stored.
Hi...i purchased this remote and have now lost the
Check out http://www.remotecentral.com and look for your remote and your TV, the code is for the TV but is geared to work with your particular remote, so look under Jenson Remotes and then find the code for your particular TV or VCR or CD player or whatever you want to program. They should also have the instructions on how to set the code into your remote and you may find a manual there too.
Not finding what you are looking for?