20 Most Recent Haier 42EP24S 42 in. EDTV-Ready Plasma Television - Page 9 Questions & Answers

Because it has a built in tuner there will be a delay since the tuner has to process all bands for each channel for analog and digital signal.

You need the upgrade kit - make Sears come out and order it for you - they know all about it, claim that the monitor should have been recalled. Mine was out of warranty, however I convinced them to fix the TV.

Many of the issues with this hunk of junk can be fixed by Sears through a "3 cards and a chip" upgrade - Sears will order the parts for you after they come out and see that sure enough, your monitor hasn't been upgraded (after the upgrade is completed, a sticker is placed on the monitor) which you most likely haven't had done. The chip will fix the problems you're having. I claimed this as "manufacturers issue" with Sears, since they know about the problems with these monitors and they did the work for free. The parts need to be ordered by their tech rep, then they are sent to your house, with instructions and if you're a little handy you can install everything yourself.

Do you mean alot of snow in the picture? Most of the time snowy pictures and or interference while using basic cable are caused from those cheap push on cables that are provided with VCR's and VCR/DVD combos. If you have one connected, remove it, throw it away and purchase one that uses screw on type "f" fittings.

have seen ysus pcb cause this problem on this model,It is not a cheap repair.Get it checked but get estimate before agreeing to pay for repair.,

have a tech check your tv for repairs the problem is in the video section if you have warranty take it back to supplier you bought it from.good luck

I had the same problem with the picture being unstable or breaking into left and right sides. I finally purchased Monster cable component video cables and all the problems went away. I can change resolution just as the product spec says. I can choose 480i or 480P or 720P or 1080i, I would try 1080P but I don't have any box capable of that resolution but I'm sure it would work.

Hi, It sounds like the pixels are bad. I would return/exchange it. But that's me... Regards, Danx

Try reset TV using instructions given on page 13 of manual.See troubleshooting section on page 16.User manual Haier L42B1180 (English - 19 pages)See page 43 of service manual (roubleshooting)https://www.manualslib.com/manual/1065697/Haier-L42b1180.html?page=44#manual

One of the most common issues is that the circuit breaker or power breaker of your TV might be faulty. You can check if they are working fine for this issue. There can be simple causes of this problem too such as the plug or remote control defects. If the above solutions do not work, you can try contacting Haier's service hotline and book an appointment to check your TV Sorry.

Hi, please remove all accessories from your tv and monitor it to see if it runs into it's glitches again. Please also remember if you purchase a new remote when this issue started happening or did you start using direct tv ? You can also run a power cycle on the tv if this issue occurs again. Thank you.

You should enter its service mode menu to do that. Visit these sites by a desktop computer and type in the model number of your set at the search window at the right side of the site to reach it very fast. Mobile view have no search box. https://electronicshelponline.blogspot.com/ https://elektrotricks.blogspot.com/ https://electrohelponline.blogspot.com/

You can try unplugging the TV for a bit to see if that resets it. Next check if the TV was set to use external speakers by accident. Finally, try a factory reset. Please add a comment with the model of the Haier TV for directions for checking the audio output menu and factory reset. I hope this helps. Cindy Wells (I had a different TV from a different brand that had no external audio port. It would sometimes lose audio on one channel or several channels. Unplugging the TV solved the problem; the factory reset option in the TV menu didn't resolve the issue.)

Most air conditioners need water removed, not added. They act as dehumidifiers as they change the air temperature. What model air conditioner do you have? The Haier HPRD12XH5 has a blinking red LED with a triangle symbol to indicate the unit is flooded. Air conditioners can also fail if there is a coolant leak or the room is too cool. If the removed water freezes in the air conditioner, it can damage the fan and cause the motor to overheat. The air cooling systems that need water added are "swamp coolers". That's the term I learned for the old-fashioned fan + ice/water cooling systems that work well in low-humidity environments. They'll make the area feel hotter in high humidity conditions. I hope this helps. Please add a comment with the model of your unit for further information. Cindy Wells

Yes you do

Normally you need a remote to access the Input Source. All televisions need a remote! If you can access Input, just scroll through them one by one until you get the signal. Replacement remotes are typically $12 to $20. Some Haier as $31. Add your model number after the word 'Haier'. https://www.google.com/search?q=haier+tv+replacement+remote ..

Your backlights have failed and need replacing, parts may be hard to find

it needs a tv repair service tech

Remove the batteries of remote control and press the on/off button for 1 minute facing the remote towards tv set. Then put the batteries back and yesss!! It works ??

If you don't have a remote, Go to the menu where it says run channel auto scan, hover over the run button and .(on the tv) press volume up, volume down, input and menu at the same time. This (depending on your model) should start the scan