Sony BRAVIA KDL-32S2000 32 in. LCD HDTV - Answered Questions & Fixed issues

The finger below is pointing to the HDMI ports. If your TV doesn't have these ports then you don't have the ports available.

There is no way to really check a T con without a lot of test equipment, only thing that is serviceable on that board is the small fuse that is by the LVDS connector...

Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary. .

Probably in the menu settings if there isn't one on the remote

If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ Line faults & possible causes to LCD & Plasma screen are given with illustrations. You can get an idea about the fault to an extent. Faults to all LCD & Plasma screen are similar, irrespective of its brand and screen size. Search the site by type in the "brand name" to your device; (Exclude the model number), in the "Search box at the top right of the display window of the Homepage" to get gathered related posts

It cannot install.you only need a flash disk and load it with the fimware and nothing else inside.

Crack open your power supply again and take a look to make sure all caps are intact and not blown or bulging. Next check the main board for any possible caps and resistors, not likely as there is an external ps but possible. If you don't see anything odd then there may be an issue with the controller chip in which case you could replace but it would probably work out to the same price as buyin a new tv

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electro-medical.blogspot.com/ http://electronicshelponline.blogspot.com/ Firmware (Software) update procedure to many popular brand TVs and other devices are given in detail.

Set-up (Programming) procedure is too much to type in here, and is not practical and it will differ brand-to-brand remote controls. If you wish to get more; check the sites linked here. It has set-up code list & set-up procedure to many popular brand remote controls. One among it has general set-up codes to check with TVs and other devices are given, in the order of the 'device's brand name list' in alphabetical order. Pull up older posts. Search the sites by type in the brand name to your device in its search box at the top right part of the display window. It will help you to find the document easily. http://remotesearch.blogspot.com/ http://electro-medical.blogspot.com/ http://electronicshelponline.blogspot.com/ http://electrohelponline.blogspot.com/ Search the site by type in the brand name of your device, in the "Search box at the top right of the Home page display" to see the set-up codes to your device, with different brand remote controls.

If you have dropped some food crumbs in there or dryed up coffee??...it might have stopped pressing on the PCB board..
open the case carefully with screw driver....
you may have to break a glue bond to...
clean the insides carefully and put back together.

I plugged this code in and it worked:

10000

Good Luck

Two possibilities.

1. The corrupted Firmware.
2. Main system control IC fault.

Remedy

• Firmware update
• Replace the main system control memory IC.

http://electronicshelponline.blogspot.com/

If you wish to get some details; visit the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/ Type in the brand name of your device, in the search box [at the top right] of the display window and the Search will start at once as you type in, and will show you all the related posts. It will make surf easy. Faults & possible causes to LCD screen are given with illustrations. You can get an idea about the fault to an extent.

Flickering can be adjusted. If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/

Hi Edison In past years the Television used Analog components throughout the TV internals. There was RGB Circuitry (Red Green Blue) and all sorts of things that could be adjusted (and go wrong). Thats not the case any more. It's all digital just like your computer and memory. So... lots of high density IC's (chips) and not much to fiddle with or adjust. The HD Display reflects what is stored in the computer video memory. All Large Scale Integrated Circuits. There are ribbon cables & connectors that get loose or bad connections and then there are the electrolytic capacitors that leak or chemically break down. So unless you are an electronics guy & know something about components there isn't a lot you can do. Reset the Bravia box. Power Off / On Etc. Check the connections on the back. Perhaps a loose HDMI connector if the signal is coming in from another source. Unlikely though. Try bumping the TV from different angles or a slap on the back. If there is a bad internal connection then the colour may return in an instant. This would be an immediate clue to the cause. If all this fails to make a difference... Then it's probably a chip failure from something like internal overheating. Take it to a dealer or technician (cheaper) rather than have them come to you. They have better facilities in the workshop and they will need to open it up. In most cases they will not fix to component level any more. They will just replace the motherboard or whatever with a factory replacement. Hopefully repair is covered by Warranty or Insurance. Cheers

Contact any service technician or the authorized service center for Sony. http://electronicshelponline.blogspot.com/

You will find the user guides in different languages by clicking here.

Power screwdriver.

It is possible that Twin Picture function is enabled, turn it off with remote/ menu options.
If this is not the case then T-Con board sounds bad and needs to be tested/ replaced.
Qualified tv tech will test and replace it.
Thanks.

There are no fans inside your 32 inch Bravia. I don't know the sound you are asking about. Is it a high pitch squeal? Is it a low volume humm? In either case you may hav e a bad filter capacitor or a problem in the Dolby noise reduction filter. In any of these cases, the filter cap in any location on the board can create the first sign of a problem. For starters, always suspect your filter caps.