20 Most Recent Belkin Pre-N (F5D8230-4) (DBF5D82304) Wireless Adapter - Page 6 Questions & Answers

Please check the Network Range B/G/N Signal. This could be the issue if other aplications are able to connect. Also try to delete Wifi Profiles using the USB and add fresh wifi networks If not in install & reinstall the the USB Software on ur pc / laptop Lastly if this doesnt work try to use the USB Adapter on another network / other device and try to connect If it doesnt then u have a USB Issue Cheers Eddie

Review this link I hope this will fix the issue link:http://www.keypostings.com/2017/04/25/set-up-vpn-belkin-router/

Hello,

The person that configure your router must have put a security key during the process of configuring your dell laptop with your router, that is why the internet explorer of the toshiba is demanding for a network security key.

Do you type in any security key while using the dell laptop? if you do, then it is the same key, you will enter on the toshiba to pass through the router because the security key is on the router.

Also If you can contact the person the person that configure the router, he should be able to tell you what the security key is.

take care.

Connect a LAN cable from Belkin to your laptop/computer's LAN port, open a browser on your laptop/computer and enter the Belkin's configuration URL. http://192.168.2.1 The default PW = blank (just press Enter) You can now change the default admin password. You can now configure the wireless settings to protect your wireless network and Internet from unauthorized access. Now configure the wireless card in your computer/laptop with the router's wireless settings. To secure your wireless network from unauthorized access, please click on this link and follow my instructions :- http://www.fixya.com/support/r3559128-wireless_router_security

You can also try to connect this device using a wired connection to your computer or laptop Running Windows 7 or Windows 8. The first thing to do, is make sure that you press the little reset button on the device so that the device memory is cleared. Then all you have to do is open up Google browser or Internet Explorer and type in 192.168.2.1 and hit enter, and that will bring you to the Belkin Setup Menu. From here you can add this device to any home or office network just follow the on-screen step-by-step instructions

You have to go into the setup for the router. Most default to the 192.168.1.1 IP address. You would type that address into your internet browser and hit enter. Then you will be asked for a name and password. If you have your belkin manual it will tell you the default name and password. Once in the settings you can change the password. You can also turn off SSID broadcasting, enable the highest level of security that your particular router supports in conjunction with your computer and enable MAC authentication. If you enable MAC authentication you have to type in the MAC address for each device you wish to have access to the router.

you can only use 1

If this is a Belkin N300 router the default username and password will be the following : Username: admin With one of the following passwords : Password: password Alt. Password: 1234 Alt. Password: 12345 If you have ever changed the username/password and have forgotten them, you can reset to default by following below procedure (This will reset all settings to factory defaults) : Press and hold the "Reset" button for at least 10 seconds, and then release it. The lights on the Router will momentarily flash. The "Router" light will begin to blink. When the "Router" light becomes solid again, the restore is complete.