Furuno GP7000F/NT GPS Receiver - Answered Questions & Fixed issues

HelloGo to page [2-6] of its user manual. All adjustments to be done to get the water teperature has been described here with details. It is difficult ot get all these details by this window, as it contains tables and charts, whci cannot be uploaded by this window. OK.

you must run 50KHz for deep water, so you will have to solve the interference problem to benefit from the power

the leading edge of the ducer should be higher than the aft portion. The leading edge must not be below the bottom of the transom. To determine if it is turbulence or radiated interference, put the boat in neutral and run motor up in RPM, if it fails then, with boat stationary, then proximity to motor is a problem and you should buy and in-hull ducer. glueing the transom ducer may or may not work well.

This unit has built in sonar, so no DFF1 is required. The 1KW transom mount is in stock here, with the proper Furuno 10 pin connector. That is all you need, the display, the power cord, the GPS antenna, the transducer and THE BOOK! We are a Furuno dealer in the Great Lakes

thanks my problem is fix

Question edited for clarity.Page 75 of the manual refershttps://www.manualslib.com/manual/1183586/Furuno-Gp-39.html?page=75Menu - System - LanguageMenu (the U with two dots over it Umlaut) - System - Sprache..

303030 try this is a original one

There are set by you to feet, metres, 'F or 'C, knots, kph, or mph.From a bit more reading, depth is Feet, distance is Nautical Miles. Temperature you have a choice.Note: The water temperature graph can beset on or off (See page 11-4.). The temperature scale is fixed between 20-80 °F (0 to30°C).Read the manualhttps://www.furunousa.com/-/media/sites/furuno/document_library/documents/manuals/public_manuals/gp1650fdf_operators_manual_version_m.pdf..

You would obviously be better served if you learned how to google it https://downeastboatforum.com/threads/1650-battery-replacement.12881/

https://www.youtube.com/watch?v=AQW4EoQPM00 hope this helps if so leave some feedback 8]

https://www.admiralty.co.uk/AdmiraltyDownloadMedia/AVCS/ECDIS-Install-Guides/Furuno3000%20User%20Guide%20S-63%201%201.pdf https://www.admiralty.co.uk/AdmiraltyDownloadMedia/AVCS/ECDIS-Install-Guides/Furuno3000%20User%20Guide%20S-63%201%201.pdf

Possibly voltage too low, faulty unit, no power coming to the unit.

try going to the ships register and applying for the changes there will be a marine department that will point you in the right direction

Radar type????

Try this 303030

A trick that I have found with the marine Furuno products is that they remember the state that they were in the last time power was removed from them. In the unit is off when you remove the AUX power than when the AUX power is turned back on the unit will remain off. If the unit was on when the AUX power was turned off then the unit will be automatically turn on when power AUX is turned back on This feature keeps the unit alive if power is disrupted under way so that the helmsmen doesn't have to keep turning it back on during busy times.

You can interface the GP30 to the 1715 and get Lat/Lon readings where the cursor is. The GPS has extra wires in the power cable. The 1715 will require a NMEA cable pn 000-154-028. Connect the white GPS wire to the yellow radar wire and the blue GPS wire to the green radar wire.

will not enter navigation.

Hi. Check here my friend http://www.mods.dk/manual.php?brand=furuno Good luck.

Ron

If you are still looking for a Navman 900 manual, It is available from Plastimo.go to www.plastimo.com/uk/services/manuals.php

Nick