20 Most Recent GE PSS26SGR Stainless Steel Side by Side Refrigerator - Page 7 Questions & Answers

have you checked in the back of it??

https://www.google.com/search?q=%23WR55X129&rlz=1C1CHBF_enUS757US757&oq=%23WR55X129&aqs=chrome..69i57j0i30l3j0i5i30.519j0j4&sourceid=chrome&ie=UTF-8

You might give this business a call with all relevant information. https://www.appliancepartspros.com/ge-board-with-core-wr55x10942p-ap6048447.html I think this is the part but of course you would want to confirm. Here is another potential resource. https://products.geappliances.com/appliance/gea-specs/GSH25JFXWW/parts

your do not need that type of outlet your fridge freezer is drawing more current than it will handle

Clean the drain to the drip tray. They block with a sort of slime mould. Use a compressed air can, or a piece of wire. https://www.google.com/search?q=GE+GSS27RGMF+WW%2C+water+is+building+up+in+the+bottom+of+the+water+and+ice+dispenser ..

best bet will be to call in a local repairman

Unplug it for 5 minutes and try again. But..... Voltage spike damaged the control board is likely. Damages Claim to the Utility company supplying your electricity.

This link might help: https://www.google.com/search?q=GE+PSS26MGPA+fan+noise+in+ice+maker&spell=1&sa=X&ved=2ahUKEwjZ6ozVj7LvAhUWX30KHSA0BlcQBSgAegQICxAv&biw=1366&bih=625

Won't warm water, despite the fact that high temp water switch is in on position (l). Water container is connected. Directions cautioned that heated water capacity would be obliterated if high temp water tank ran dry. This won't ever occur. Unit bought Sept 2004. House meld isn't blown. (Power plug working and green light on unit is "on") Checked to check whether temperature limiter was stumbled by setting hot change to off (O) for five minutes, and afterward set to on (l) for 30 minutes. Intensely hot pointer light on front of unit doesn't turn on showing warming cycle. For more info - http://oxymembrane.com/

lift shut off lever or turn off water valve

low on freon

possible low freon

check defrost fan

Defrost heater or defrost thermostat

possible bad motor to eject ice

possible recirculation fan in freezer going bad if fridge warm also possible temp sensor make sure compressor stays running

An appliance parts suppler can provide that information.

When the compressor is replaced, the coolant must be removed, fit the compressor, bring the system down to a vacuum then refill with coolant.I would get the refrigeration guy back to check for a leak caused by a bad installation.By the way, FREON is no longer used at it causes depletion of the ozone layer.

If it is a newer model you can look for set screws on the inside of the handles. Use a small allen wrench to loosen the set screws and lift up on the handles.

is there an electrical schematic in the appliance?