20 Most Recent Sharp AR-5316 Advanced Digital Imager Copier - Page 8 Questions & Answers

check on this urlhttp://drivers.downloadatoz.com/vendor_sharp-corp/sharp-ar-2120/os_windows-7.html

Installing the scanner/printer use software driver CD or download from the website for the correct operating system software of your computer. Newton

enter service code # interurpt c interupt , machine goes off then enter 14 then press print button. this will cancel error code H4.

The Fuse might of blown. or the power board on the unit flashed. try replacing the fuse or different cable if that doesnt work then its the power board

For H4 enter the following codes # interrupt C interrupt 14 Start button twice For ch check whether all the doors(side door,front door) are closed.#Kintu Dennis Kentus

F2 04 Content Improper cartridge (Destination error, life cycle error) Detail The destination of the machine differs from that of the CRUM. The life cycle information is other than "Not used (FFh)." Cause CRUM chip defect Improper developing unit Check and remedy Replace the CRUM chip. Replace the developing unit. Identificat ion error The trade mark code of the CRUM differs. The company code of the CRUM differs. Model error The boot program model code does not coincide with the CRUM model code. Type error When the CRUM type is other than genuine/ conversion/production rotation. Destinatio n error The machine destination differs from the CRUM destination. Data abnormali ty When an error value is included in the initial check information. When the max. toner supply time is 00. When the print hard stop is 00. Misc error When the Misc information is other than "Not used (FFh)

# -interupt-c-interupt

replace toner OR replace toner cartraidge chip

what are your product Sharp OR Toshiba

This means that the cartridge's sensor is miscommunicating with the copier memory thus the code U2 -40. You should clean the inner sensor connector and the toner sensor of the spilled toner by low blower. Perform this code ;# , interrupt , C, Interrupt keys in that order and press 16 then Print key and the code will be cleared.

There are several F2 codes. If you press and hold the start / copy key the machine will show your sub code. Re-post quoting full code and we can try to help.

H5-01 is caused by multiple jams at the exit. Try resetting via pressing clear, interupt, 0, interupt,14,1 start button.

Drivers for Sharp AR-5316 are available at Sharp Official Support site Click here and make selection as under: -

Select
AR5316 > Windows (XP, Vista, Windows 7 etc) Depending upon the OS you have.

Hope this helps! Dont forget to rate the solution!!
CreativeTECH

That model uses a TD cartridge so when you replace the toner the developer is included. The crum chip on the TD cartridge will reset the counters and sets the developer.