20 Most Recent Sharp AR-5316 Advanced Digital Imager Copier - Page 5 Questions & Answers

U8-99 error of the target of the operation panel

requiring the intervention of the technician.

no. i cant print. its showing red light and user guide attention

try to chek if the actuator of the exit sensor is ok you will find it when you open the side door exactly attached to the heater try to check the end is it in plase or not if not use sim 30 sub1 to check all sensors you wil solve your problem

replace thermistor

crop 14

check mounting of ic reciever on back of copier and then check ic connects propperly intoreciever when toner is inserted

Crum IC on toner cartridge has an issue

H3-00 = Fusing section high temperature trouble check thermistor and thermostat

Your heater lamp maybe busted.

Use the simulation 14 to cancel the error..

If nothing happens then you need to check your heater lamp.

Driver Sharp AR-5220 Please.

E7 codes deal with the optical scanner unit and or the laser unit. It could also be the lamp in the scanner unit. The E7 is the main code. There is a sub code associated with it. To view the sub code hold down the start button. Below is a list of specific codes and their meanings:
E7-02: LSU trouble
E7-10: Shading trouble (Black Correction)
E7-11: Shading trouble (White Correction)
E7-12: Shading Trouble
E7-16: Abnormal laser output
If it is a laser (LSU) issue then the LSU may need replacing.
If it is a shading error the first step is to remove the platen glass carefully (with the power off because the inverter board). There is a thin white strip on the bottom side of the platen next to the slit glass. Clean this white strip with a soft cloth and a small amout of isopropyl alcohol.
Dust on the optics can also cause shading reference errors so gently blow off the mirrors with canned air.
Perform the following key procedure to reset error:
"#" key, Interrupt key, "C" key, Interrupt key
"1" key, "4"key
Start key, "CA" key.
See if unit cycles and comes back up. If not turn off and then back on the main power.
If error reappears on site technical service may be required.

the most jam problem with this machine are:

1. jam in the paper pickup (cassette)
2. jam inside (fixing unit)

to avoid the paper jam problem with this copier; you need to use the correct paper weight (80 or 90 gr) if you are using 60gr paper you will always get the jam problem.

is there an error code? is there a red light blinking on the panel?

need to replace chip

C-Interrupt-0-interrupt-14 press print key

C-interrupt-0-interrupt-14-press print key

need to replace toner chip

C-interupt-0-interrupt-14 press print key.if problem not fix .you must be replace lamp or fuse