20 Most Recent Motorola Mobility H300 Wireless Headset - Page 2 Questions & Answers

it should be 0000. zeroX4 as with so many bluetooth devices unless it comes with screen that will allow you to enter your own but this is not the case


if it works for you don't forget to rate me

turn off headset

then press on hold on button untill the light stays on then run your blustooth.

hope this helped

The default PIN for this headset is 0000

press and hold power button from an off position and it will be in find me mode.

the two buttons on the side at the same time turn mic off
and again at the same time turns mic back on.

just pressing one at a time will raise the volume and the other is to lower the volume

if your computer has bluetooth than the answer is yes.

i can help
512 807-9336
or

u have to select in the audio section.


anytime just call

if your laptop has bluetooth
then the headset will connect.
forsure
512 807-9336
i promise

turn off headset
then press and hold on button untill the light stays on
not blicks i mean stays on on
then run your other bluetooth discovery
on your laptop

THe factory code to pair is usually a simple code like 0000 or 9999 or 1234. Try these simple codes to see if it will work.

also posted to your other request: Moto headsets are usually either 0000 (four zeros) or 1234

Moto headsets are usually either 0000 (four zeros) or 1234

Use this manual for the bluetooth to tell you how.

http://www.motorola.com/mdirect/manuals/QG-H300_9495A08A.pdf

http://www.motorola.com/mdirect/manuals/QG-H300_9495A08A.pdf

Check the manual to make sure your setting up correctly.

http://www.motorola.com/mdirect/manuals/QG-H300_9495A08A.pdf

Did you hold the call button down for more than a few seconds?

Check the manual out to make sure your doing the correct process.

Link- http://www.motorola.com/mdirect/manuals/QG-H300_9495A08A.pdf

I am in the same situation. I've lost the ear piece for my H300.

Your in luck though! I found some on EBAY for 4$. Check this link...

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=110442976246&rvr_id=&crlp=1_263602_263622&UA=WVF%3F&GUID=67311f751250a04371d333d3fff9ccba&itemid=110442976246&ff4=263602_263622

Yes just use the passcode 0000

you can name the headset anything but the passcode is 0000

Not on the headset. The ringtones are stored in the phone

try pairing and entering the code 0000