20 Most Recent Motorola Mobility H500 Wireless Headset - Page 8 Questions & Answers

It could as easy as updating your phone by dailing *228 with a Verizon phone, select option 2 then press ok when the update is complete. When the phone resets, turn on the bluetooth headset, a prompt on the phone should come up to enter the passkey which should be 0000

See the user manual page 59 for instructions on how to pair the device from the 8800. You only have to do this once.
The passcode is 0000 for the H500 which is unalterable.

Try power cycling the phone. Turn the Nokia off, wait 10 seconds, then turn back on and try again. It really does help sometimes. Let us know if this doesn't help.

Turn the Samsung off, wait 10 seconds, then turn it on and try again. Power cycling the phone really does help sometimes. Let us know if this doesn't help.

Make sure the wall socket you plugged in is working. You may need to turn on a light switch, etc. The light should come on when you plug it in and go off when it's done charging. Try charging longer. Leave it plugged in overnight and try again.

FLIP IT OVER

0000 - this code is default Bluetooth pairing code for the H500 and can't be altered.

are you holding the call button until the light stays lit/ That is about 6-10 sec and press find devices after it stays lit from your handset

go to your settings and make sure that the microphone is set to headset.

0000

Hold the phone button down for about 4 seconds.. The light should blink 2 times and then stay on to add device to your phone once connected light will go out...Hold button down again light will blink 3 times and go off...........

Real easy go to the iphone and settings go to bluetooth and it will said in discovery mode.
then go through the pairing of your headset sontrols and the iPhone will say enter password then enter 0000 or whatever your H500 manual says.
If you have already paired the H500 with another phone you need to reset that. this is also covered in the manual which can be found online at motorola.com

The factory number is 0000, if it was changed, look on the manual to find a way to reset it.

I just pressed all the buttons at the same time until the light stopped blinking and then, it reset the headset to pair again.

press the talk button for 11 seconds see how the light start blinking

you need a dongle or bluetooth card installed both come with drivers

look at online guide or call manufacturer for intructions on how to reset. I forgot mine and in the manual it had a reset code. hope this helps

-Be sure the headset is fully charged.(plug it in till the light turns off.)
-Hold the talk button down for 4 seconds or until the blue light goes solid (not blinking.)

Now the device should be ready to pair with your Blackberry. It usually only stays in pairing mode for a short while (approximately 90seconds)

the pass word is 9999 or 0000 unless it has been used before it is the factory setting.