20 Most Recent Motorola Mobility H500 Wireless Headset - Page 4 Questions & Answers

Here are the steps to put it into pairing mode. Also please make sure you click the YES button below my response here to indicate my answer was helpful. It would mean a great deal to me if you could do so. Thank you

1. With the headset power off, press and hold
the Call button for 6 to 10 seconds until the
blue indicator light turns on and remains
steadily lit. (The light will flash while you
hold the Call button.)

2. If the indicator light is flashing or does not
remain steadily lit, turn off the headset and
repeat step 1.

Most phones use either 0000 or 1111.
Other can just automatically connect to the headset when
following the steps to pair a device.

Hi,
Pass code for motorola headset to pair with blackberry mobile is 0000
Thank You

Hi, To pair your motorola headset with phone please go to below website.
http://www.motorola.com/mdirect/demos/how2_h500/h500.html
This website shows you video guide how to pair the head set to phone.
ThankYou

Hello and Welcome to FixYa!

Here is the link for the desired manual, Click here
Have a good day,

Concerned,
Waqar.

Try "0000"

The manufacturer part number 89127J for this headset is, and the battery it takes is 140 mAh Battery

try holding the button and pulling the mic down after 2 secs

Start with your headset turned off. Then, press and hold the call button for 6 to 10 seconds, until the indicator light is steadily lit (it will flash as if it was being turned on, but don't release the button at that phase). It is in pairing mode. Now make your phone's bluetooth application search for new devices. After a while, the H500 will appear on-screen. Select it and make it connect. If a pairing code (or PIN, or passkey) is requested, enter '0000' (four zeros). If the pairing process is successful, the indicator light will flash rapidly, and then, it will enter the stand-by mode. Otherwise, turn your headset off, and go through the whole process again.
Hope you are able to sort your problems out.
Regards, Carlos

go on to settings accessory settings paired devices add new turn your device on find it type in 0000 it will work

Individual ear holders are not sold, i would recommend you replace the item.

0000--all zeros

0000

here is the manual for the headset
http://www.starbatteries.com/moh5blheowma.html

half way down the page click on "View the product manual..." and open it.

Motorola states that the pairing code is "0000" and can not be changed.
make sure it is fully charged before pairing.
hope it works.

Usually, the pairing code is 0,0,0,0, all numbers. The phone must have blutooth AND be turned on, as well as the earpiece.

I would contact Motorola and find out what the problem is with your headset.

Hold the phone button down for about 4 seconds.. The light should blink 2 times and then stay on to add device to your phone once connected light will go out...Hold button down again light will blink 3 times and go off...........

Hold the phone button down for about 4 seconds.. The light should blink 2 times and then stay on to add device once connected light will go out...Hold button down again light will blink 3 times and go off...........

0000