20 Most Recent
Honeywell Programmable Thermostat Heater - Page 5 Questions & Answers
Manual foe a RCH9300WF
It's pretty basic actually. I've done this with
Nest and Honeywell Lyric. The only thing you need to do is removing the current thermostat from the wall and connect the new one.
Set it up using your mobile application and you're good to go.
1/26/2017 11:12:54 AM •
Honeywell...
•
Answered
on Jan 26, 2017
Heat will not turn off
I can speak for ades. Is the burners and everything on, or is it just the fan blowing? Please reply, as the solutions for each are much different.
6/14/2016 7:27:26 PM •
Honeywell...
•
Answered
on Jun 14, 2016
I am installing a new thermostat for my baseboard
One wire is "IN" the other is "OUT" A Thermostat works by "Breaking" the "Phase" line. It is just that simple. You usually have a pair of wires that connects, on the "Hot" side, to the always power ON line, & neutral. The Circuit, or Load, on the "Cold" side, has a a pair of contacts that open & close depending on Thermostat, in series with that conductor.
Hot Contacts Cold
P In-------------------><-----------------P Out
N----------------------------------------------------N
3/18/2016 10:29:47 PM •
Honeywell...
•
Answered
on Mar 18, 2016
I need programming info for an Altech model
Can you please tell me how to set clock for central heating the clock is an althc001 had power switch off and when it was turn back on the clock is not working when the boiler is calling for heat and the same with the heating can you help
3/8/2016 12:42:57 PM •
Honeywell...
•
Answered
on Mar 08, 2016
Aux heat comes on
If you turn your heat on and the temperature is set 3 degrees above what the actual temperature of the room, the auxillary heat will automatically come on. The auxillary heat is an electric heat strip that provides heat to your home while the heat pump is in defrost cycle or if there are extremely low temperatures outside. Try not to set the temperature more than 2 degrees above the actual temperature of the room. Hope this helps.
2/13/2016 7:04:49 PM •
Honeywell...
•
Answered
on Feb 13, 2016
I want to change my TH6110D1013 honeywell
You need to go into the setup mode to change it. Push and hold the i button along with the increase and decrease buttons. All the segments on the display will appear for about three seconds, then setup number will appear to the left and factory setting to the right. Change the setup number by pressing the (i) button until you get to 14. This is the degree temp. display, factory setting is 00. Use the arrow up key to change to 01 (celsius).To exit setup, push and hold the(i) key until the display returns to normal.
1/14/2016 3:37:19 PM •
Honeywell...
•
Answered
on Jan 14, 2016
Not finding what you are looking for?