20 Most Recent HP LaserJet 1200 Printer - Page 6 Questions & Answers

dear sir good day this problem is used to happen with HP printer because of the separation bad ... it went old and fuzzy and need to be replaced because it not going to feed paper to the printer any more ....so please call the next company that sells HP printers original sp and by the separation bad and make them also replace it for you thank you

You need to change toner cartridge for new one.
Most problems of quolity from it.

If is not help you, it may be broken termo fuser - go to service.

Try a different toner cartridge if you have one available. 90% or more of the time this is going to be a cartridge issue.
Good Luck

uninstall the full software and reinstall it again from...

http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?lang=en&cc=us&prodNameId=29790&taskId=135&prodTypeId=18972&prodSeriesId=29789&lang=en&cc=us

Go to the HP website and get the driver. Here's the link: http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?lc=en&dlc=en&cc=us&lang=en&product=439320&

Hp website will give you the driver for installation

try a different cartridge ... if nothing changes you probably have a torn fuser film.

your probably out of ink. go to officemax or something and tell them the model number and kind of printer. they'll get you the right toner/ink cartdrige and you just go home and follow the instructions on replacing it. good luck!

If your printer is already connected to a computer and working, all you should cdo is share it. Right click on its icon (under printers and faxes from control panel and select share). Then gradually the printer will automatically install it self all over the network. But if you to use it urgenty on the network manually configure by going the respective computer. Go to network places/view workgroup computers, double click on the computer with the printer. your will see the printer icon. double click on it to install.

noise is caused by the toner cartridge and paper is not going trough because there is a plastic milar clse to the feed roller that is bent,find it and push it towards the inside of printer (is a black or dark brown plastic mylar)

Pull out the toner cart and look at the drum....it should be clean. If it is clean, you have a worn out fuser, if it's dirty you need a new toner cart.

you need a repair kit, the pickup roller is the problem.
you can get a repair kit for around $30.
http://www.laserprinterkits.com/category_s/24.htm

what is the problem actually printing left side or right side or upper down. First check tonner cartridge, if its of then check printer leser unit just clean it again.

If the printer works fine for you, but doesn't work properly for someone else I would assume user error. Just make sure that there is plenty of paper in the tray and that it is centered. Also look around for any small peices of paper that might've gotten stuck near the tray, preventing new sheets from getting pulled.

If you have installed the toner cartridge correctly then it is a hardware problem called the Fuser and is the most common problem with printers...the fuser is a part of the printer which actually melts the toner onto the paper. The fuser has to get up to a high enough temperature to be able to melt the toner, if it is malfunctioning then it cannot give you a dark print. You may search google for Fuser information: Recommendation is change out fuser to repair problem. Pls rate this solution.

Fuser sleeve is failing