20 Most Recent
HP LaserJet 1200 Printer - Page 4 Questions & Answers
Hp laser jet 1200 catrige
Remove your printer from the PC and uninstall the printer software. Now reinstall the printer software and connect the Printer to be detected and installed. Check printer properties to see the ink levels.
Use head cleaning before a test is taken . It is possible that the head is not reacting to the need of the command , can be an issue with ink drying , can also be poor ink cartridge contacts
My hp laserjet 1200 series
Turn off computer,turn off printer disconnect comm cable for 5 min,reconnect reboot should stop intermitted printing
Printer wont pick up paper
Open the printer and take out the cartridge, then you see paper pick-up roller it is rubber. The roller is dirt and have to be cleaned with cloth and water or alcohol.
My laserjet printer started making load noises and
Use the following checklist to ensure that the print cartridge is still operable:
-
Ensure that the print cartridge is seated properly.
-
Inspect the print cartridge for remaining toner.
-
Check the expiration date stamped on the print cartridge box.
-
Check the print cartridge to see if it has been disassembled or refilled.
-
Inspect the print cartridge to see if toner is leaking through worn seals.
-
Check the surface of the photosensitive drum in the print cartridge to see if it has been damaged or scratched. Touching the drum contaminates the photosensitive surface and can cause spotting and image defects.
-
Blurred areas on printed pages indicate that the photosensitive drum in the print cartridge has been overexposed to light. Because overexposure to light causes permanent damage to the photosensitive drum, the cartridge should be replaced.
The HP LaserJet 1100 series printer cannot print to the edge of the paper, to get the image to fit into this printable area, slightly reduce the size of the image.
try this and let me know, also check the status of the toner.
mail me- [email protected]
I have an HP 1200
The motor is stuck, Remove the toner, you should remove the covers for this one. Start at the back cover and remove it 1st, the side covers will slide off and expose the drive gear ***'y. move the small motor gear with your finger (dont damage the teeth with a pair of pliers. untill it becomes easy to turn (the tray will slowly go back to it's rest position.
The cause for this is the solenoid on the front right side. Take it out and clean it, make sure to remove the sticky residue on the underside of the actuator.
make sure the 2 cam followers on the front edge of the tray are clean also.
Hp lasserjet printer 1200 motor will not stop with
It could be a flipped wiper blade in the printer cartridge. Does it make the same noise if you take the cartridge out? If it does not then you should try rotating the green drum on the bottom of the cartridge towards the back of the cartridge (the bigger half) and then reinstall it. If it persists and you're fairly positive it is the cartridge installing a new one will fix it. If it is not the cartridge the machine might need servicing. We are fairly proficient with laser printer repair in our Cartridge World store, and our corporate office started recommending similar training nation wide for our stores. I would call you local Cartridge World and see what they can offer you.
I want hp laserjet 1200
Hello,
HP have an excellent support website. Just go to
www.hp.com/support
answer the country Q? then enter your product name as prompted, select your op.sys then you're there!
Regards,
Nicam49
Red light on hp laserjet
If it wakes up with a red light and there isn't paper jammed up in the machine then a component (probably the toner cartridge) is bad. If you have already replaced the toner. Then it's possible a part needs to be replaced in the printer.
Not finding what you are looking for?