20 Most Recent Maytag PAV2300 Top Load Washer - Page 5 Questions & Answers

see this causes:It spins, but doesn't pumpdrain line is clogged, remove some sock with pliers+test the pump for defective propeller, and replace DO NOT REPAIR It doesn't spin or pumpfrozen pump puller +and replace the pump It pumps, but the water returnsif the drain hose reach more about 4 inches, cut of the excessif the hose is lower, install air/gap siphon break assemblysee the diagram.God bless you

hmm...so you're certain that the cold water is actually going in someplace huh? ok, try this...run it like you have it now...put your hand in the water flow and feel how hot or warm it is...now turn off the cold water and see if the hot water gets hotter...if it does,then try the opposite, turn off the hot water and see if there is still water coming into the tub...let me know what happens

Does it fill and wash, but just won't spin the clothes out? If so, you will need to replace the lid switch.

Loctite sounds the order of the day. Don't overtighten once the thread lock is in place and allow to cure before using machine.

first check the house breaker and make sure you still have power. If it does then I would unplug the machine and lean it back against the wall to look at the motor wiring harness underneath to see if it came loose or is wet.

its broken and needs to be replaced

same thing happened in mines i put it though a hot wash with no clothes or washing powder it seemed to do the trick

Remove the tube from the water level switch. Blow it out so the sediment will stop blocking the tube. Re-attach it and pump out the water. Retry. If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

i would concentrate on moter moters have a limit not replacable , the whole moter would need to be replaced also check the lid switch this can cause a intermitant issue . as far as fixing or replacing its a issue you need to weigh out .

chech the small hose on the back of the drum, acsess it from the back in the middle. That hose comes off, it will leak and cuntinue to fill

remove center cap then there is a bolt unscrew it