20 Most Recent
Panasonic VIERA TH-65PV500 65 in. Plasma Television - Page 8 Questions & Answers
No screen vision or sound,plugs checked,mains
Hello,
There are two places to look for the problems, the backlight inverter board and the power supply. Look at the power supply first since it is easier to get to, look for burnt parts, bad capacitors, etc. Look for 5vdc, 12vdc, and 24dvc.
You can look at the sample of the power supply board, the picture with the soldering side has labeling of what you should have on the output of the power supply, yours may be labeled on the top side of the board, there are high voltage on the board so you must be real careful, if you are not sure, let the professional handle it if you do not have the basic electronics knowledge
Since you do have sound, that means you do have the 5v and the 12v but may or may not have the 24vdc for the backlight inverter.
Hope this helpout
Cleaning screen
Use good quality cotton cloth that has little moisture to clean tv screen.
Do not use detergent, any kind of spray or glass cleaning liquids etc.
Only use cotton cloth dumped with moisture of clean water.
Thanks.
How do I turn on my TV?
The tv power supply board is dead,that the board where the power a/c cord plug into it.That the power supply board.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.
Wont turn on. when i try, it just 'clicks'
Power supply board,that the board where the power a/c cord plugin it.The power supply board is dead.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.
Our panasonic 51 viera tv won't turn on 10 blinks
Take it to a TV repairer. You could be going around in circles and getting nowhere.
Ten blinks - Check Q8014 and Q8013 for shorts, leakage,
or bad solder connections on the " D" board. If the transistors are
bad, check R8051 and IC8005, also on the "D" board. Some of our Viera's may have different part numbers. Consult the service bulletins
Please rate my help++++Thanks for using FIXYA
Sound god but no picture
hello,
You most likely have a backlight issue with this TV set. Could be the
inverter circuits for the backlights. The inverter is the power supply
source for the backlights. there could also be a screen driver
problem. This would entail changing the entire board. You should call
in an authorized LG repair center to check this set out for you. Good
Luck and please let me know what you found out about this TV set.
I have sound but no video
Hello,
well this is common on your model and could be a few different things. one is the video circuit and a cost would range around 100.00. the other is a weak picture tube this would cost more than the TV . sometimes when it is the tube we can adjust it but it does not always last long. sounds to me it would be better to invest into a newer TV in this case.
good luck :)
My 53
Ur tv power supply board it dead.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.If u know basic electronic's and soldering?Searches all around the power supply board and it supporting boards look for these parts call capacitors,it dead it,they bulges up on it top or puff up on it top.These capacitors are dead,replace them,your tv power will be stable again and work.
Can not figure out how to get the CC to work on my
For the set you can activate the CC in the setup menu. But some cable, sattelite ect. receivers have to have teh close caption turned off or on in the setup menu there or you do not get the cc signal to the set.
Not finding what you are looking for?